Ford Bronco II Questions Maintenance & Repair
Hydraulic Clutch
is there any way to bleed it?
Ford Bronco
got a 89 ford bronco || 2.9 engine cranks bt wont start any suggestions?? was running fine then just died out while driving
No Spark On My 86 Bronco 2
i was being a dumb ass and drilled right through my wireing harness and caused a short. i fixed the wires that i cut, used a test light to test the wiring to the starter relay, tfi module and replaced...
Bronco Want Stay Running
I have a 1989 bronco II that when you crank the engine it will run for a second or two then cut off. I have replaced both fuel pumps, i have fuel pressure at the rail and about 40lbs of pressure on th...
Cab Visor
Hello I'm looking for a 89" ford Bronco II cab Visor and haven't been able to find one anywhere. I'm up for suggestions on where and if I'm buying from a private party how to not get ripped off. Thank...
BRONCO 2 WILL NOT START NOT GETTING FUEL
WE WERE IN A WRECK AND IT RAN FOR A WHILE AND NOW IT WILL NOT START
89 Bronco II Mystery Coolant Leakage Down Back Of Eng
2.9 Ltr, 4WD, 5-Spd. Coolant drips from under vehicle, between transmission and engine on passenger side. Changed intake gaskets, both upper and lower, checked freeze plugs. Coolant is not getting ...
Starting
I have had electrical issues with my bronco 2. The major problem is every so often when I go to start my bronco the starter will stay running. I've had it in the shop and my mechanic cannot get ...
Whats Wrong?
Me and my friend were tuning up my truck. I let him take the spark plugs and wires. Now my truck wont start. I've looked front to back in my haynes book. I took everything out and started over. I have...
Turn Signals Don't Work
turn signals don't work, but hazards work and fuses are good help please
88 Bronco 11 How To Install Front Wheel Bearings An Race Seals
front hub how to install iner outer wheel bearing an race grease seals
What Size Is The Clutch
2.9 liter 5 speed 4x4 what size is the clutch
4-WHEEL DRIVE WONT WORK
MY FREIND SAID HE UNPLUGGED SOMETHING AND I DONT KNOW WHAT!
Why Dont I Have Break Pedal Pressure?
master cylinder was blowing back into resivour so i assumed it was bad and replaced it with a new one. that did not change a thing. there are no leaks in the system.front brakes grab just before the p...
Takes A Few Seckonds To Start
when i turn over my bronc II it takes a few seckonds to start is that norm?
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.