Ford Bantam Questions Any type
Ford Bantam Engine Cranking But Not Sparking And Starter Not Turning Please...
hi i have got ford bantam 1.3 2006 cranking but not sparking and stater not turning, but when touching with wire does turn fuel pump working ,please assist how to sort the problem
Ford Bantam 2010 1.3 Rocam
my ford bantam cuts as if its a petrol but still start and moves but it cuts at some point
Motor Not Turning Over
After replacing the distrubitor cables and cleaning all the spark plugs the enjin won't turn over or start
Noise In Engine
when I accelerate in any gear too hard, I get a kluging sound, until I relax on pedal. Change CV's both sides. still have problem. Sound seems to come from where left drive shaft goes into gearbox/...
Enquirer
Hi im looking for a place to get new bantam spares, most scrap yards sell me stuff without guarantee ,and they are expensive and unreasonable
Repair
I have a ford bantam rocam doesn't start when it starts it has no pulling power sorry my english not so good
Engine
My Ford bantam 2007 1.3 rocam has a problem of engine sound the plugs are not all firing and when I check them they are wet with oil. What may be the issue
Ford Bantum 1.3l Not Firing
hi all i have just swoped engines on my bantam but cant seem to get it started. the motor swings and i have spark but still not firing. i have noticed the anti theft light at the clock is permanentl...
Gauges Slow To Move
Good day, Ford Bantam 1.3 Rocam 2006.....when I start my bakkie, or put in petrol, all the gauges takes a few seconds (sometimes longer) before it starts to register and for the fuel needle to go up...
Indicate Lights
Indicate lights are on and off on my ford bantam 2010 TDCI. What may be the reason?
Inner Cv
I bought a new complete drive shaft of my bantam roacam, it's still noise on the inner cv. I went to 4 mechanics. No one get it right. My car is a Roacam 2005. My email :mkgarimetsa2005@yahoo.com
Clutch Too Hard
Hi Unclear, I have put a new master clutch cylinder, slave cylinder,clutch kit. Clutch is too hard and inside are engaging but the car is not taking them. Ford bantam rocam engine 1.6 whatcould be...
Bantam Start Failure
Hi i drive a 2005 1.3 bantam rocam . When its starts i can drive it no problem when i switch it of then it doest want to start again . e left it over night and this morning started up no problem. ...
Fuel With Water
Water mix with patrol
Leaking Fuel , Water And Bakkoe Is Overheating. Ford Rocam 1.6
Hi we just replaced the head gasket on bakkie , but now there seem to be a whole lot of trouble with it . After the gasket were replaced they started the bakkie it started but oil leaking from the ...
Missfire
Good day 2002 Ford Bantam 1300 Rocam I have changed coil pack, plugs, TP censor and still it missfire 2500 and 4500 RPM what can I do or charge to fix it
Rocam 1.3 2003 Model
My car was mixing water and oil. Took it to the engineers. The top engine was skimmed. The rings, valves and timing chain were replaced. Now when it starts it cant hold power. The foot needs to be...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.