Ford Bantam Questions Any type

Knock Sensor Ford Bantam

Hi I'm putting a spitronics PCM management on my 1.3 ford bantam rocam. The diagram requirements is tdc sensor power, tdc sensor signal. Do I connect it to my knock sensor or do I go for the cam...

Fuel Consumption Of My Ford Bantam

Hi Guys, my Ford Bantam 1.3 rocam consume petrol like a camel drinking after a long journey, what could be the problem, I had replaced the oxygen sensors after the mechanic diagnostics

Bantam Cold Start Problem

I have a 2011 1.3i Bantam Battles to start cold, 8 or 9 turns and it eventually fires up, engine turns fine Once its running its perfect, no misfires etc runs like a dream Replace spark plugs/cords/pe...

FORD BANTAM ROCAM ALTERNATOR, BATTERY STARTING PROBLEM.

Hi guys and gals! I have a Ford Bantam 2006 1.3. Little bit of history: I have had her complete engine replaced approximately 4 years ago. I didn't do much driving for 2 years due to the main reason...

Rocam Engine Won't Start

I have bantum 1.6 rocam engine, I recently had piston rings changed, a week later while driving bolt holding cap on piston rod 3 ,broke and broke the oil sump and engine block, I had another subas...

Difference Between Right And Left Shaft

Car Problem

Hi I have a ford bantam rocam and I just changed a gear box but with an old working one and I can't hear the fuel pump run the sound of it when I turn on the key I used to hear the sound of it, I che...

Hi

Don't really known help

MISFIRE

Hi I have a rocam 2011 it starts and idles nicely but when I drive it misfires and hold back almost as if the engine wants to cut off...

Radiator Fan Problem

It's turning immediately after starting the engine

Ford Bantum

Hi,i got a problem with my car ford bantam rocam engine,when i taking the terminals the car goes off immediately,I've tried to replace new carbon brushes but still the alternator doesn't supply th...

Ford Bantum

Hi, I got a problem with my car ford bantam rocam engine,when taking out the terminals from the battery the car goes off immediately I've tried to replace new carbon brushes but still the alternato...

My Ford Bantam 2008

Hello is there maybe someone who can help me with advanced on my Ford Batam 1.3I 2008 My list of Problems 1:My bakkie is idling between 1200&3000 2:My bakkie is loosing its power well driving re...

Buying A 2006 Ford Bantam

Hi I'm looking to buy a 2006 1.3l Ford bantam. What should I look out for on the car and ask the dealer .

Ford Bantam Rich In Fuel

Oil Cooler

Hi, have a 2003 1.8 Deisel Ford Bantam Endura De. The oil cooler is packing up and sourced a second hand part. Part fits but looks different. Part number 93FF-6B856-AA. Can I use this part? The old p...

Bantam 2007 1.6 Rocam Will Not Start

I have spark, fuel pressure and engine cranks. I have swapped starter relay. Fuel pump inertia switch has been disconnected and bridged. Tested the NTC temp sensor. All is working as it should. An...

Hi I Have A 2006 Ford BBantam With Rocam Engine . We Repared The Top After ...

Bantam 2006 Inner Fan Only Work On 1,3,4 Not On 2.did Replace A Resistor.St...

Rocam Engine Sudden Cutoffs

ave a 2007 Ford Bantam Rocam engine, the car starts ok, idle for about 2minutes or more and thereafter suddenly cuts off. I've replaced the coil pack (non-genuine) and leads but still faced with t...