Chevrolet C/K 10 Questions Any type
- Recently Active
Will a 1964 gmc v6 305 manual transmission bolt up to the Chevy 5.7 engine
1 have an 1984 silverado 4x4, I want to upgrade the steering column to one that has cruise and radio controls integrated into the steering wheel, what other years of Silverado columns would fit?
My battery box rotted it deposited side arc on the hood and now it won't charge or the charge lights on but it's obviously not charging
I put a 89 1 ton 454 serpentine belt driven motor in my 82 Scottsdale four wheel drive. After putting a new radiator in it now vapor locks. The big block has headers.
Blew my in line 6 on my 82 c10 . Gonna replace with 350 ,just wondering if my tranny will fit ?
I'm pulling a t5 manual transmission and pedal assembly put of a 92 chevy s10 ..and was wondering if it would work in my 1982 chevy C10 pk
My auto tranny still goes in gear but doesnt pull and doesnt move in 4x4 either after it warms up but when I let it cool down it will move again I think my torque converter is bad
after installing the engine & trans the old 2 piece drive shaft is 2" to short for the carrier bearing to be bolted. what drive shaft do I need ? and who do I get it from
how do you access the speed nut for cab corner molding from the interior? The nut is covered by an interior sheet metal panel that seems to require rear window removal to get to the nut. Hopefully ...
I replaced light bulbs, brake switch, headlights and dimmer switch but the brake/service lights don’t work. I’m getting voltage to the hardware because the signal lights work normal.
I am buying my first truck. A 1985 Chevy k10. it has 305 in it, it’s got some big tires, has 55k on the dash but the owner does not know if there original. Has a few problems with the speedometer ...
I am goi to buy my first truck an 85 k10. The frame was redone no a single bit of rust. had a 305 in it. It has 50k on the dash but the guy does not know if they are original or not. He is thinkin...
Looking for a sliding bench seat to replace the PO's whack job of putting early 70s Camaro buckets in. Luckily he used the original mounting holes and made weird brackets. I'd like something with a ...
I have a 77 k10 and recently when I go over medium to large bumps my truck shakes violently then corrects itself if I slow down I noticed one of the shocks is crushed but would that cause it, it h...
How much adaptation would the NV 3500 -speed transmission require to mate with a 1971 Chevy C-10 2 wheel drive 1/2 ton truck with the 250 six cylinder engine? Bell housing bolt pattern, clutch and...
I have a 1985 chevy c10 while driving it seems to choke and almost turn off i wanna know what’s wrong,it have no muffler it only has the cats could that be why?
I was driving on the highway and smelled something burning the truck turned off. I looked and it was the fusilige linkage. I repaired the linkage and now truck wants to start but will not. Also t...
I have a 85 Chevy and I was wondering if I could put a 69 camaro engine in the truck
Truck runs pretty good in cool weather. Has trouble when the weather gets warm. Acts like the fuel has been cut off while driving. Loses power but doesn't typically die.
Search Chevrolet C/K 10 Questions
Chevrolet C/K 10 Experts
#3G A ArneReputation700
Find great deals from top-rated dealersSearch
Related Models For Sale