300zx Clutch wont engage

Asked by Christopher Sep 04, 2010 at 07:01 AM about the 1996 Nissan 300ZX 2 Dr STD Hatchback

Question type: Maintenance & Repair

Was working fine on my way to work. Got on the freeway put on the cruise control and about 30 minutes later when I went to shift as I was exiting, I couldn't. I don't see any leaking, though I am going to double check.  Never heard any wierd noises coming from the clutch, there was no indication that anything was going bad. Any ideas? This happened once before with my 280 Zx. the slave cylinder just went out while I was at a stop light, so I'm thinking this may be the same problem?

1 Answer
60

Emroldiz answered 13 years ago

Its probably the slave cylinder. I have run into this issue twice since I bought my 1987 in 90. Check to see if the clutch fluid is low - if so - that is the marker - take to the nearest Nissan repair expert - new one with install should not run more than $300 and should be done in a few hours. You will be bak to new - that or take your chances and drive with clutcj fluid to top off after every road trip.

1 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • 300zx Clutch wont engage 1 Answer

    Was working fine on my way to work. Got on the freeway put on the cruise control and about 30 minutes later when I went to shift as I was exiting, I couldn't. I don't see any leaking, though I am goin...

    1996 Nissan 300ZX 2 Dr STD Hatchback

    -

    Maintenance & Repair

  • new clutch kit in my 1990 300zx still have slipping 1 Answer

    I just had a clutch kit installed was still slipping adjusted the clutch pedal a few times.. but once Warmed up it will not move at all. I release clutch while in gear and engine doesn't even stall...

    1990 Nissan 300ZX 2 Dr Turbo Hatchback

    -

    Maintenance & Repair

  • my 91 300zx wont rev over 3500 rpm 1 Answer

    i bought a 91 nissan 300zx in september 2013 and it ran great sat in a shop over the winter and now after it warms up the idle bounces between 300 and 2000 and when in gear it wont go past 3500rpm a...

    1991 Nissan 300ZX 2 Dr Turbo Hatchback

    -

    Maintenance & Repair

  • i have a 1986 nissan 300zx that i wont accelerate when I press the gass... 2 Answers

    I have a 1986 Nissan 300zx that it wont accelerate when I press the gas, sometimes it will work but when it does not it will take like 20 seconds to go.. is like it losses power... after that it will...

    1986 Nissan 300ZX 2 Dr 2+2

    -

    Maintenance & Repair

  • 95 300zx fuel needle drops car wont start? 3 Answers

    car was driving ok last night. Had 1/4 tank gas now this morning while trying to start fuel gauge needle drops all the way and car wont start????????

    1995 Nissan 300ZX 2 Dr 2+2 Hatchback

    -

    Maintenance & Repair

Shortcuts

Search Nissan 300ZX Questions

CarGurus Experts

  • #1
    dandyoun
    Reputation
    410
  • #2
    Jamie Staples
    Reputation
    400
  • #3
    macevanscb
    Reputation
    350
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet Corvette
35 Great Deals out of 860 listings starting at $14,900
Used Toyota Supra
3 Great Deals out of 46 listings starting at $50,000
Used Porsche 911
22 Great Deals out of 268 listings starting at $22,980
Used Chevrolet Camaro
16 Great Deals out of 478 listings starting at $11,999
Used Ford Mustang
43 Great Deals out of 1,636 listings starting at $5,999
Used Mazda RX-7
3 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.