s300 chip datalogging and calibration...
Asked by Joseph Anthony Jan 19, 2012 at 10:23 PM about the 1996 Honda Civic DX
Question type: Car Customization
i have a Hondata s300 ecu module and the software... will the calibration for JDM D15 Civic work if i apply it to my current D15y7
equipped civic and will it produce error codes even if i disable datalogging and spool error check? will it bypass the d15y7 current
logs?
5 Answers
NO it is not compatiable,it will thro out codes.
Joseph Anthony answered 12 years ago
then what configuration must i look at and what codes should i consider?
Joseph Anthony answered 12 years ago
will i stall on a certain point? because i have the Hondata s300 with OBDI but a relatively lower hp engine (3-stage vtec) than the stock 1996 Vti... should i swap anything?
best thing to do is cold air induction and a header.
Joseph Anthony answered 12 years ago
i already have the SiR 4-1 headers and an intake... ran the diagnostic tool and thankfully there are no error codes except for P0507 Idle Control System RPM higher Than Expected .. engine runs fine except the rpm is a bit higher.. might take it for a spin to see if the engine runs too rich...
