Why does my 2000 Dodge Intrepid blows cold when it's turned to heat and we changed the thermostat and it put new antifreeze in and it still blows cold . What do I need to check next.

Asked by Wilson2976 Nov 13, 2015 at 08:31 AM about the 2000 Dodge Intrepid FWD

Question type: Maintenance & Repair

When I drained the car of the water /
antifreeze when I changed the
thermostat it was a brownish color
and looked like it had darker spots in
it like something was mixed in with it.

5

dwsmith63 answered 8 years ago

I just bought a 2000 intrepid and had the same problem. i had to try and blow out my heater core and it got a little warmer but after I changed it the heat is all good now.

Mark helpful

Your Answer:

Why does my 2000 Dodge Intrepid blows cold when it's turned to heat and we changed the thermostat and it put new antifreeze in and it still blows cold . What do I need to check next. 1 Answer

When I drained the car of the water / antifreeze when I changed the thermostat it was a brownish color and looked like it had darker spots in it like something was mixed in with it.

2000 Dodge Intrepid FWD

-

Maintenance & Repair
I have A 2000 Dodge Intrepid 2.7 V6 and I drained & changed the thermostat in it bc I had no heat and put antifreeze and water back in let it get warm an still blows ice cold. What do I need to do? 1 Answer

It blows ice cold air when turned to heat and it has never run hot on me since I bought it but it just blows cold air when the knob is turned to heat. Please tell me what I can do next. Thanks.

2000 Dodge Intrepid FWD

-

Maintenance & Repair
replaced radiator,thermostat,and bleeder valve still over heats 9 Answers

hi i have a 99 dodge intrepid 2.7 L and i replaced a bad radiator because the old one was bad ok done so i was running at good temp circulating fine but no heat ok thermostat right? i replaced the the...

1999 Dodge Intrepid ES FWD

-

Maintenance & Repair
I have a 2000 dodge intrepid 2.7 starts and runs fine until it gets to normal operating temp then it spits and sputters even backfires then dies until it cools down and the process repeats whats fix? 1 Answer

I have a 2000 dodge intrepid runs fine until it reaches normal operating temp then starts sputtering and backfiring and dies till it cools down then the process repeats how do I fix this?

2000 Dodge Intrepid FWD

-

Maintenance & Repair
I got a P0340 on my '96 intrepid ES. Cam position sensor. I replaced it, but still no go. Put the diagnostic machine on, and still I get a P0340 code, even with the new sensor. What gives here? 1 Answer

I am only getting one code reading on the OBD reader, and that is the p0340. Not sure what the hell else is wrong, but i am not pushing any other codes. If I blew my timing belt, i am certain I would ...

1996 Dodge Intrepid ES FWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.