My 2006 Mercury Milan is having turn signal problems.. Car reads check turn lights on the front. Both replaced and the driver side stays on permanently and drains my battery. We replaced the switch in the dash board and it still isn't working.. Any help guys?

Asked by Jeannie Mar 31, 2013 at 08:23 PM about the 2006 Mercury Milan Premier

Question type: Maintenance & Repair

18,695

Michael answered 11 years ago

There are several items. It could be a defective signal switch. It could be a problem with the body control module. There are a few others. I would start with checking for diagnostic codes and go from there.

2 people found this helpful.

Mark helpful

Storm answered 4 years ago

Ok I'm having the exact same problem new bulbs no popped fuses still stays on I'm stumped here

Mark helpful

Your Answer:

My 2006 Mercury Milan is having turn signal problems.. Car reads check turn lights on the front. Both replaced and the driver side stays on permanently and drains my battery. We replaced the switch in the dash board and it still isn't working.. Any help guys? 2 Answers

2006 Mercury Milan Premier

-

Maintenance & Repair
My 2006 Mercury Milan is having turn signal problems.. Car reads check turn lights on the front. Both replaced and the driver side stays on permanently and drains my battery. We replaced the switch in the dash board and it still isn't working.. Any help guys? 1 Answer

2006 Mercury Milan

-

Maintenance & Repair
AC question for 2007 Merc Milan, short trips AC blows cold, longer trips 1-2 hours AC works great for a while, the stops blowing cold and blows hot. If I cut the unit completely off, still driving, in 15-20 minutes, turn unit back on to AC, bingo, works great again for 1-2 hours. Of course, when taken to Mercury Dealer, they can't find a problem, it's working great, "if it anit broke we cant fix it". Yep, I know. Only does this on 1-2 hour trips. Help ! Was told it is a blower door problem. However, I hear water/ice sounds when turned off. Is it freezing up? Blower door? Help needed. 2 Answers

short trips AC works great, longer trips on road trip 1-2 hours, blows cold then all of a sudden blows hot. I have found through trial and arrow while driving same trip, shut off unit completely fo...

2007 Mercury Milan I4

-

Maintenance & Repair
I have a2008 murcery Milan v6 with codes P0102,0113,0356,0355,0354,0353,0351. All the coils have been replaced and the manifold gasket replaced. Still shifting bad in 1 stu and 2nd geer .will the tran 1 Answer

The transmission control module supposedly needs to be changed to fix the shifting problem and first and second it's getting a bunch of cones but he coils have been replaced and the gasket manifold ...

2008 Mercury Milan V6

-

Maintenance & Repair
Why would the engine shake at idle and check engine light be on? 2007 Milan 3 Answers

After being warmed up the car runs fine but it is shakes and sounds like a fourwheeler when its running at first start up.

2007 Mercury Milan

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.