Chevrolet S-10 Questions Car Customization
Will A 89 S10 Frame Fit Under A 2000 S10 Reg Cab?
My 2000 s10 regular cab needs a frame, will one from an 89 work?
If I Wanted To Drop A V8 Into A 1998 2.2L S10, What Supplies Would I Need T...
The more specific the better. Also, on a tight budget, so cheap=good
Do I Need A Lift Kit To Change Rim Size On My Truck?
I have a 2002 Chevy S-10 ZR5 and I am wanting to go from a P235/75R15 to a P265/65R18 and my question is can I do it without a lift kit, or do I need a lift kit and if so how many inches?
I Have A 1992 S10. And I Want To Supe Up My Car I Want To See What Kind Of ...
Would i have to change the drive shaft..or rear axle?
I Have A 91 Chevy S-10 Small Bed I Want To Know If P225/7R15 Tires Would Fi...
Size of my tires i have a question about. I have a 91 Chevy s-10 small bed I want to know if P225/7R15 tires would fit this.
Electrical
I have a 91 S-10 with a 350 carburetor, it was a V-6 fuel injected. Looking to remove or by pass the on board computer system. Right now the fuel guage and speedometer quit working. Any ideas where to...
Is The Rear Drive Line On A 1992 Chevy S10 Short Cab Short Bed The Same Len...
4x4, 108" wheelbase vs. 118" wheelbase
NEED ADVICE! Lowering My 94
i just installed a 3 inch belltech lowering kit for my truck, it came with the drop shocks and spindles for the front and i put the drop blocks in the rear. after it was all said and done my truck had...
4.3 VS 302
I have a 1985 S-10 Low-rider, the engine I have in it is a tired 2.5, with no mods out there that I can find. Everyone and their uncle has a S-10 with 350 and up in S-10's, nothing is wrong with this,...
What Can Do I Do About My Rear O2 Sensor?
I have an 04 Chevy s10, I'd like to customize my exhaust but I don't know what to do with my rear O2 sensor without it throwing a code & Check engine light. (Meaning removing the catalyic converte...
I Have A Set Of 292 Turbo Heads They Have Stainless Valves Three Angle Valv...
Need to run or do I have to find a cam with matching springs I have a 700r trans all rebuilt kevlar bands monster kit and a 3000 stall converter or do I run a 350 turbo ?
I Have A 1996 Chevy S10 And The Guy I Got It From Said It Had Lowering Bloc...
O I need to take the wood out and put in the right blocks
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.