So I got a new transmission the beginning of 2014,and about 6 months later the temp gauge started staying on hot but not smoking or anything I'm going to sell it but would like to fix it first any sug

So I got a new transmission the beginning of 2014,and about 6 months later the temp gauge started staying on hot but not smoking or anything I'm going to sell it but would like to fix it first any sug 1 Answer

OK, I also have a 2003 Dodge Intrepid Interceptor, it has been broken down for a little while with what I was told was a hole in the head gasket. I am debating on if it would be better to sell it or try and get someone to repair it for me. I love this car but its just sitting right now. Hoping for some good advice. There are pictures of it in my garage. 6 Answers

after blowing a radiator hose it wouldn't drive far without over heating, but would sit and idle for ever without heating. Mechanic in New Mexico couldn't figure the problem out for a week and after ...

I got a P0340 on my '96 intrepid ES. Cam position sensor. I replaced it, but still no go. Put the diagnostic machine on, and still I get a P0340 code, even with the new sensor. What gives here? 1 Answer

I am only getting one code reading on the OBD reader, and that is the p0340. Not sure what the hell else is wrong, but i am not pushing any other codes. If I blew my timing belt, i am certain I would ...

Temp gauge fluctuates, then reads hot and engine sputters during idle. When I turn off car, then wait a minute and start it again, it will fire up but not stay running. 1 Answer

At this point the temp gauge is over the 3/4 mark to Hot and if I wait for the car to cool down it cranks up and runs fine. Is this a thermometer issue or a computer issue? The coolant level is fine...

I have a 2000 dodge intrepid 2.7 starts and runs fine until it gets to normal operating temp then it spits and sputters even backfires then dies until it cools down and the process repeats whats fix? 1 Answer

I have a 2000 dodge intrepid runs fine until it reaches normal operating temp then starts sputtering and backfiring and dies till it cools down then the process repeats how do I fix this?