i start driving my car later about 3 min the oil light comes out. it doesn't come off until i turn it off. what's wrong?

i start driving my car later about 3 min the oil light comes out. it doesn't come off until i turn it off. what's wrong? 4 Answers

I have a 2005 Bmw 330i zhp. I was driving out of a gas station when it suddenly started making engine noise, then the oil light came on, then the check engine light. I drove it about 2 miles home where i parked it. I scanned it and now reads p0012. I changed out the Vanos sensor $200 later and it did not fix. I have checked the oil filter and it looks okay. I run 93 octane and use castrol fully synthetic with perfect changed invtervals. I reset the code and the check engine light went away but the oil light is alluminated from the start and its RED. The engine makes a ticking/knocking noise as if it has something inside it rattling. Just got the car back a few weeks ago from the transmission shop $2500 LATER and now its doing this. I dont know what it could be and i cant just continue to throw money into it. Can anyone please tell me what this could be? this is really hard on me as its my only car.. 4 Answers

I have a 2005 Bmw 330i zhp. I was driving out of a gas station when it suddenly started making engine noise, then the oil light came on, then the check engine light. I drove it about 2 miles home wher...

I PUT A 2000 5 SERIES BMW MOTOR IN MY 3 SERIES 1999 BMW AND USED THE WIRING HARNESS OFF THE ORIGINAL 3 SERIES WHICH I HAD TO AND NOW THE STARTS AND IDLES FINE WHEN YOU REV IT UP IT SPITS AND SPUTTERS 3 Answers

I PUT A 2000 5 SERIES BMW MOTOR IN MY 3 SERIES 1999 BMW AND USED TEH WIRING HARNESS OFF THE ORIGINAL MOTOR OUT OF THE 1999 3 SERIES AS i HAD TO BECAUSE THE WIRING HARNESS WAS DIFFERENT ON THE NEW MOTO...

I was parked along side the road to wait for a friend so i shut the car off, it would not restart, i rolled it and pop started it, then it died/shut off & would not restart? 3 Answers

the car wont turn over, all lights will turn on but the lights are very dim, car wont even attempt to turn on, check engine light came on & i tried to read the codes but it didnt work for me, me and ...

Why does my bmw 320d 02 plate keep going in to limp mode when launching off start but when I start off slowly and then launch it works fine. I have had it plugged in and it come up low air pressure. 1 Answer

Also I can not plug my air flow mass meter in because it stays perm entry in limp ( the air flow mass meter is brand new)