My 86 2.8 seems to have a slipping clutch. When I let the clutch out in any gear it revs very high like there's a stripped bearing and then slowly engages when you give it gas. Ideas? It's underpow

My 86 2.8 seems to have a slipping clutch. When I let the clutch out in any gear it revs very high like there's a stripped bearing and then slowly engages when you give it gas. Ideas? It's underpow 1 Answer

im having a problem, i took apart the caberater on my 1988 fiero and cant find the correct places to put the vaccum lines, i know where they go i just dont know which line to which, it ran fine before i took it apart, now i think that the lines are switched around, can you tell me what goes where or shoow me a site where i can find out, like a car manuel site? 2 Answers

i had to take the valve cover off and that reguired that i take like a senser that is covering one of the bolts, in the process i found that two of my vaccum lines had broken so i took the carb off be...

I have a 1986 Fiero 4 speed manual and I have replaced the clutch and slave cylinder and it still wont shift what could the issue be? 1 Answer

When you turn the car on and go to put it in reverse all it wants to do is grind the gears and when you try to put it in the other gears it stops and don't go shift. What could be going on?

Clutch getting stuck after car sits over night/ drives for a while with out pressing the clutch. 1 Answer

Recently my shifter started getting stuck in 5th gear only when driving at highway speed for an extended amout of time, now it gets stuck in any gear when i go to start my car. I usually have to pum...

While driving down the highway, my 1986 Fiero SE suddenly backfired, lost power, then regained power a few seconds later and was ok. Any ideas on what caused it? That's the 1st time it has done it. 2 Answers

Occurred during highway driving, when it happened I lost all accelleration ability for a brief couple of seconds, then everything came back and was fine.