Heat will not stop coming through the vents of my 99 Chevy Blazer

Asked by Oren Mar 10, 2016 at 11:30 AM about the 1999 Chevrolet Blazer LT 4-Door 4WD

Question type: Maintenance & Repair

When I turn my heater off hot air still seeps out of the vents
even when I turn the thermostat switch all the way down to
66 degrees. Could it be the blend door actuator
malfunctioning? It's getting really hot so I need to address
this situation as quick as possible any advice would be
greatly appreciated.

Myoungblood answered 8 years ago

Yes it sounds like your actuator is stuck open allowing the engine heat in.

1 people found this helpful.

Mark helpful

Sue answered 6 years ago

Vacuum line from outside to inside

1 people found this helpful.

Mark helpful

Your Answer:

Heat will not stop coming through the vents of my 99 Chevy Blazer 2 Answers

When I turn my heater off hot air still seeps out of the vents even when I turn the thermostat switch all the way down to 66 degrees. Could it be the blend door actuator malfunctioning? It's gettin...

1999 Chevrolet Blazer LT 4-Door 4WD

-

Maintenance & Repair
my 2001 chevy Blazer heater will not work, the AC works great but no heat 1 Answer

the AC works great but when i turn the knob to heat it still blows cold air

2001 Chevrolet Blazer LS 4-Door RWD

-

Maintenance & Repair
My 1996 Chevy Blazer will not start 2 Answers

I have changed my fuel filter my fuel relay is good I change my distributor cap and rotor and it still does not start it crank but did not start what could be the problem

1996 Chevrolet Blazer 4-Door RWD

-

Maintenance & Repair
'99 chevy blazer will not turn over!!, and don't know ANYTHING about fixing vehicles :( 3 Answers

i have just bought a 99' chevy blazer and three days after putting insurance on it the thing shut down. first it was we ran out of gas so put gas in the tank and tried to start. would not start so ...

1999 Chevrolet Blazer LS 4-Door RWD

-

Maintenance & Repair
I have a 1999 Chevy Blazer, 4x4, 4.3 vortec. We have changed the coil pack, fuel filter, distributor cap and button, the crank shaft sensor, cam sensor and plug wires as well as the ignition control module. We coming to a stop sign it will stall and sometimes when just sitting still. Sometimes it will start right back up and other times it takes several tries. I also have the oxygen sensor on order and it should be here tomorrow. Fuel pressure tested perfectly. No black smoke, no smell of rotten eggs or the cat glowing red. The only code that comes up is PO420. 4 Answers

I have a 1999 Chevy Blazer, 4x4, 4.3 vortec. We have changed the coil pack, fuel filter, distributor cap and button, the crank shaft sensor, cam sensor and plug wires as well as the ignition control m...

1999 Chevrolet Blazer 4-Door 4WD

-

Maintenance & Repair

Used Chevrolet Tahoe

14 Great Deals out of 783 listings starting at $6,730

Used Jeep Grand Cherokee

125 Great Deals out of 3,819 listings starting at $4,999

Used Chevrolet Silverado 1500

174 Great Deals out of 7,260 listings starting at $6,995

Used Ford Explorer

59 Great Deals out of 1,788 listings starting at $2,888

Used Toyota RAV4

125 Great Deals out of 3,019 listings starting at $5,995

Used Chevrolet Camaro

18 Great Deals out of 477 listings starting at $11,999

Used Dodge Durango

54 Great Deals out of 1,850 listings starting at $9,998

Used Jeep Wrangler

135 Great Deals out of 5,976 listings starting at $2,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

Heat will not stop coming through the vents of my 99 Chevy Blazer

2 Answers

Your Answer:

Shortcuts

Search Chevrolet Blazer Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

Heat will not stop coming through the vents of my 99 Chevy Blazer

2 Answers

Your Answer:

Related Questions