i got a 2000 grandam with the wrong firing order will that stop it from running or starting up

Asked by ml8080 Feb 04, 2014 at 06:33 AM about the 2000 Pontiac Grand Am SE

Question type: Maintenance & Repair

firing order

10,665

Norm answered 10 years ago

Yes. The front bank is cylinders # 1 - 3 - 5 reading left to right. The rear bank is cylinders 2 - 4 - 6. The correct firing order is 5-2-3-6-4-1. It's possible to switch two spark plug wires and still have a running engine, but it would run terrible.

3 people found this helpful.

Mark helpful

Your Answer:

i got a 2000 grandam with the wrong firing order will that stop it from running or starting up 1 Answer

firing order

2000 Pontiac Grand Am SE

-

Maintenance & Repair
On a 2001 Pontiac Grand Am GT (3.4L 6 cylinder), is the 'Bank 1, Sensor 1' oxygen sensor the upstream or downstream sensor? From what I've looked up it appears to be the upstream sensor, I just want to make sure so I don't buy the wrong part. Thanks a lot! 2 Answers

I took it to a family friend who ran diagnostics on it and was told to get a Bank 1, Sensor 1 position Oxygen sensor. From what I understand the Grand Am has two oxygen sensors.. one upstream and o...

2001 Pontiac Grand Am GT

-

Maintenance & Repair
I have a 2001 pontiac grand am gt.The bolt that holds the tensioner pulley in the engine block keeps coming out and my belt slips off! Is it possible that it has the wrong size bolt or something else? 6 Answers

The bolt that holds the tensioner pulley into the engine block keeps coming out and my belt and pulley fall off! Is it possible that the bolt is the wrong size or maybe the threads inside the block ...

2001 Pontiac Grand Am GT1

-

Maintenance & Repair
I have a 1996 Pontiac Grandam and It won't start... help please 1 Answer

I have a 1996 Pontiac Grandam and I replaced the alternator and the battery is only a couple months old, it has new spark plugs and it still won't start, it dose turn over and I can hear the fuel pump...

1996 Pontiac Grand Am

-

Maintenance & Repair
I have a 2000 pontiac grand dam 3.4 v6. It won't start up. Takes 4 trys and I have to rev it to keep it started. Once running it idel from 1000 to 500 to 300 and it continues to do this. Once it start 7 Answers

Up it runs like that. I put it in drive and it straightend up. If I drive it at a steady speed like 25 it starts to shake until I let off the gas. I replaced the spark plugs,spark wires,tps and eg...

2000 Pontiac Grand Am SE

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.