My 2.7L CRD Mercedes 5 cyl. cranks but won't start in the mornings. Garage says it looses it's fuel pressure over night??

Asked by 4close Jan 14, 2016 at 02:26 PM about the 2004 Jeep Grand Cherokee Overland 4WD

Question type: Maintenance & Repair

2004 2.7L CRD fitted with Mercedes 5 cyl. engine. Cranks fine in the morning but will not start. Main dealer thinks it's loosing it's fuel pressure over night so probably has an air leak some where in the fuel system. I've changed injectors and heater plugs and some of the fuel lines. Now I'm told it could be the black plastic non return valve that fits on top of the fuel filter. Can anybody help as this is getting expensive.

1 Answer

160

This sounds very familiar. For some time now the fuel hose, on my 2003 Grand Cherokee 2.7L CRD ( Mercedes engine), from the top of the fuel filter to the low pressure pump on the front of the engine has been gathering air from somewhere…(usually overnight). Cranking the engine for 30seconds or so sometimes re-primes the system and the engine will start but prolonging the cranking also runs down the battery! The obvious difficulty is that you cannot see any diesel fuel leaks and this strongly suggests that air is leaking into the pipe leading to the low pressure pump. This is the pump and hose combination that draws (sucks) fuel through the fuel filter from the fuel tank. (There is no electric pump in or near the fuel tank.) To prove that it is an absence of fuel in the low pressure area try drawing fuel through the priming socket that sits on the top of the engine alongside the CRD rail. The low pressure pump should now prime the high pressure pump and the fuel pressure sensor should be able to initiate an engine start. If the engine fires then you have identified the problem as an absence of fuel in the hose from the fuel filter. The question now is: How do you identify where the air is getting in? A likely suspect is any one of the tiny “O” ring seals that forms part of the preformed Mercedes fuel hoses which are not cheap and very likely to break when you try to remove the hose just to examine the O rings !!! Bite the bullet and replace the entire low pressure hose assembly (including the primer port if that has been used a few times) If the problem persists or changing the hose does not cure the problem then maybe the fuel pressure sensor has failed as well.

16 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Hornet_2497
    Reputation
    8,770
  • #2
    Gene Arnett
    Reputation
    6,960
  • #3
    thejeepdoctor
    Reputation
    6,460
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Dodge Durango
57 Great Deals out of 1,822 listings starting at $6,987
Used Jeep Wrangler
135 Great Deals out of 5,912 listings starting at $6,500
Used Ford Explorer
59 Great Deals out of 1,907 listings starting at $6,990
Used Ford F-150
311 Great Deals out of 13,471 listings starting at $4,888
Used Toyota 4Runner
20 Great Deals out of 536 listings starting at $7,770
Used Chevrolet Tahoe
20 Great Deals out of 774 listings starting at $7,499
Used Chevrolet Silverado 1500
176 Great Deals out of 7,546 listings starting at $7,777
Used Chrysler 300
28 Great Deals out of 518 listings starting at $6,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.