Nottaxspurt answered 4 years ago
Make sure you have power and a good ground to brake light socket using a test light.Also make sure you are installing the right bulb.Check for corrosion, clean contacts, if power and ground are present at socket and it still doesn't work, replace socket.
I replaced my brake light and it still doesn't work and just noticed my headlight is out both on drivers side
2000 Jeep Grand Cherokee Laredo
-
Maintenance & Repair
I got a rear passenger signal light out. I changed the bulbs an got the bulbs right from dealer. Still doesn’t work. Tried tracing the wires an found there is power to everything but that right cor...
2015 Jeep Grand Cherokee Summit 4WD
-
Maintenance & Repair
Brake lights work until the headlights are turned on then the left brake light goes out. I've change bulbs and sockets and nothing changes any ideas
2003 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
2009 Jeep Grand Cherokee. Parking lights on the driver's side don't (both front and rear) work but the flashers and turn signal works. Light's on the passenger side all work OK parking lights, flasher...
2009 Jeep Grand Cherokee Rocky Mountain Edition
-
Maintenance & Repair
2000 jeep grand Cherokee only blow cold on drivers side
2000 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.