I have a knocking in the top of the engine, would that come from the camshaft?

Asked by dbwhipple May 31, 2007 at 01:54 PM about the 1992 Ford Explorer 4 Dr XLT 4WD SUV

Question type: Maintenance & Repair

I have had top end engine noise. I have changed out the rocker arms and push rods. That helped with the chatering but there is a knocking noise. I suspect it's coming from the lifters/camshafts. What would cause that. What does the camshaft sensor do?

lightGear answered 16 years ago

Here is what I would check: 1. Wheel nuts 2. U-joint 3. Wheel bearings 4. Driveshaft

1 people found this helpful.

Mark helpful

Your Answer:

I have a knocking in the top of the engine, would that come from the camshaft? 1 Answer

I have had top end engine noise. I have changed out the rocker arms and push rods. That helped with the chatering but there is a knocking noise. I suspect it's coming from the lifters/camshafts. What ...

1992 Ford Explorer 4 Dr XLT 4WD SUV

-

Maintenance & Repair
I have a 00' Ford Explorer Eddie Bauer I have a leak coming from under the starter on the engine smell like antifreeze could that be the water pump and also it started to shutter and it had a smell of burnt wires and the check engine light started blinking off and on? 1 Answer

My 2000 Ford Explorer Eddie Bauer started to shutter and wouldn't go over 45mph my check engine light started blinking off and on then I smelled something burning like burnt wires and sulfur. After I ...

2000 Ford Explorer Eddie Bauer

-

Maintenance & Repair
I have a 2006 Ford Explorer that was totaled and I have found a 2005 Ford Explorer that has a bad engine. Can I put the engine from my 2006 into the 2005? 3 Answers

I have a2006 Explorer that was totaled but the engine is good. I found a 2005 Ford Explorer with a bad engine can I change them out to make 1 car

2005 Ford Explorer Eddie Bauer V6 4WD

-

Maintenance & Repair
After replacing the harmonic balancer and driving I have a P0340 code camshaft position sensor "A" circuit malfunction bank 1 1 Answer

I replaced the harmonic balancer and timing sensor, after test driving I now have a code P0340 camshaft sensor "A"- circuit malfunction (bank 1) any suggestions how to correct it.

2006 Ford Explorer XLT V6

-

Maintenance & Repair
I have a 1998 Ford Explorer, the temperature gage works fine, and there is plenty of antifreeze in the reservoir and the radiator. I select the controller for the front heat NO HEAT & NO BLOWER. 3 Answers

I have a 1998 Ford Explorer that blows COOL air in the rear. The rear control cluster works fine. But when it comes to the front control cluster, THERE IS NO HEAT, & NO BLOWER. I have filled the rese...

1998 Ford Explorer 2 Dr Sport SUV

-

Maintenance & Repair

Used Ford F-150

301 Great Deals out of 13,535 listings starting at $3,888

Used Jeep Grand Cherokee

133 Great Deals out of 3,657 listings starting at $4,999

Used Toyota 4Runner

26 Great Deals out of 536 listings starting at $14,791

Used GMC Yukon

13 Great Deals out of 935 listings starting at $6,900

Used Jeep Wrangler

140 Great Deals out of 5,909 listings starting at $6,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have a knocking in the top of the engine, would that come from the camshaft?

1 Answer

Your Answer:

Shortcuts

Search Ford Explorer Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

I have a knocking in the top of the engine, would that come from the camshaft?

1 Answer

Your Answer:

Related Questions