i have a misfire that is causing the torque converter to lockout... replaced plugs, wires and coil, and the car still misfires... any suggestions... i was told that if i fix the misfire i fix the car

Asked by Matt May 26, 2009 at 09:28 AM about the Dodge Intrepid

Question type: Maintenance & Repair

i have 4 codes that come back when i test it... transmissin control system malfunction, torque converter clutch system failure, a cylinder 6 misfire, and a bad 02 sensor

Joel answered 14 years ago

hAVE YOU HAD THE INJECTOR CHECKED CHRY. HAS ALWAYS HAD A PROBLEM WITH THE FUEL RAIL DESIGN?

Mark helpful

Matt answered 14 years ago

i unplugged the injector and it ran rough when it was unplugged, i take that as a sign that it is working

Mark helpful

Joel answered 14 years ago

what engine is in that car? possibly but you need to make sure you unplugged no.6 injector and not no.5 the injectors do not go where they look.

Mark helpful

Matt answered 14 years ago

it has the 3.5 engine in it... i unplugged the last injector in that bank, but i'm not sure now if it was the right one.

1 people found this helpful.

Mark helpful

Joel answered 14 years ago

chry. fires the injector on th opposite side of the intake. so try unplugging the opposite one

1 people found this helpful.

Mark helpful

69MercMan answered 13 years ago

I have a 3.5 in a Chrysler 300 that missed out and caused the transmission to down shift and up shift eratically. I was told by my mechanic buddy to change the TPS switch. Worked great no more trouble.

Mark helpful

Your Answer:

i have a misfire that is causing the torque converter to lockout... replaced plugs, wires and coil, and the car still misfires... any suggestions... i was told that if i fix the misfire i fix the car 6 Answers

i have 4 codes that come back when i test it... transmissin control system malfunction, torque converter clutch system failure, a cylinder 6 misfire, and a bad 02 sensor

Dodge Intrepid

-

Maintenance & Repair
OK, I also have a 2003 Dodge Intrepid Interceptor, it has been broken down for a little while with what I was told was a hole in the head gasket. I am debating on if it would be better to sell it or try and get someone to repair it for me. I love this car but its just sitting right now. Hoping for some good advice. There are pictures of it in my garage. 6 Answers

after blowing a radiator hose it wouldn't drive far without over heating, but would sit and idle for ever without heating. Mechanic in New Mexico couldn't figure the problem out for a week and after ...

2003 Dodge Intrepid

-

Maintenance & Repair
I have a 2000 dodge intrepid 2.7 starts and runs fine until it gets to normal operating temp then it spits and sputters even backfires then dies until it cools down and the process repeats whats fix? 1 Answer

I have a 2000 dodge intrepid runs fine until it reaches normal operating temp then starts sputtering and backfiring and dies till it cools down then the process repeats how do I fix this?

2000 Dodge Intrepid FWD

-

Maintenance & Repair
I got a P0340 on my '96 intrepid ES. Cam position sensor. I replaced it, but still no go. Put the diagnostic machine on, and still I get a P0340 code, even with the new sensor. What gives here? 1 Answer

I am only getting one code reading on the OBD reader, and that is the p0340. Not sure what the hell else is wrong, but i am not pushing any other codes. If I blew my timing belt, i am certain I would ...

1996 Dodge Intrepid ES FWD

-

Maintenance & Repair
I have an 04 with the dreaded 2.7 engine. the engine light is on and giving a code for the crank sensor. it has been replaced...twice. the light is still on and they can't even reset it. 1 Answer

I've tried 3 times to erase the code. The light does not go off and I can't get an inspection.

2004 Dodge Intrepid SE FWD

-

Maintenance & Repair

Looking for a Used Intrepid in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

i have a misfire that is causing the torque converter to lockout... replaced plugs, wires and coil, and the car still misfires... any suggestions... i was told that if i fix the misfire i fix the car

6 Answers

Your Answer:

Looking for a Used Intrepid in your area?

Shortcuts

Search Dodge Intrepid Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

i have a misfire that is causing the torque converter to lockout... replaced plugs, wires and coil, and the car still misfires... any suggestions... i was told that if i fix the misfire i fix the car

6 Answers

Your Answer:

Related Questions