Ford bantam 1.6 2006
Hi, I bought 2006 ford bantam at SMD in September ROCAM 1.6 engine,
computer box is 1.3. car was running until few days ago, the engine is cranking
but not starting. the coil, sparks and fuel filters are new
what could be the problem
3 Answers
Firstly, you should convert your computer box to a 1600 which we do. Phone / Whatsapp: 0820606425. Check the fuel pressure at the injectors. At idle the fuel pressure at the injectors should be about 2.8 Bars. When you switch the ignition to ON the fuel pump should operate for about 2 seconds and then switch off.
Cranks but not starting Cranks, but does not start. The starter solenoid wire is running in the same channel as the crank angle sensor. When the starter solenoid is energized this induces a higher voltage into the crank angle sensor wiring. Move this solenoid wire out of the crank angle sensor wiring channel. Check the condition of the main starter cable from the battery to the starter. Clean the terminals and the amperage draw on this cable. Check the earth cable from the battery negative to the body and fit an extra earth cable from the battery Neg terminal to the gearbox.
This computer box should be converted to a 1600 which we can do. Phone / Whatsapp : 0820606425
