Ford bantam not starting

Asked by Tiboe78 Jul 07, 2020 at 11:23 PM about the Ford Bantam

Question type: General

My ford bantam 2007 rocam does not start in the
morning though it cranks normally till the battery
runs flat and it needs several kick start attempts
and thereafter it starts normally after the first initial
start

1 Answer

6,925

Check the starter selonoid cable, It runs in the same channel as the Crank Angle Sensor wiring. The Starter selonoid wiring is a High voltage wire and induses voltage surge into the low voltage sensor wires. Remove the Starter selonoid wire right away from the Sensor wiring channel.

Your Answer:

Shortcuts

Ford Bantam Experts

  • #1
    Guru97FK8
    Reputation
    6,100
  • #2
    Janus Welgemoed
    Reputation
    1,020
  • #3
    AB Zaviour
    Reputation
    860
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.