my bantam 16 rocam problem

Asked by Jacquesxlt May 26, 2020 at 12:59 PM about the Ford Bantam

Question type: Maintenance & Repair

perforatedlease help my bakie isnt starting i replaced a short piece of the
electrical harnes that got little burnt dueb to short on the contactor if its called
tyhat everything is going on as normal but no fire

1 Answer


Check the starter relay. If the relay has a short circuit, there will be no spark. Check also the starter selonoid wire is removed from the same wiring channel as the crank angle sensor wiring. When you crank the engine to start the higher voltage from the starter selonoid wire induces a high voltage in to the Crank angle sensor wiring, and there will be no spark. Separate these two wires.

Your Answer:


Ford Bantam Experts

  • #1
  • #2
    Janus Welgemoed
  • #3
    AB Zaviour
View All

Find great deals from top-rated dealers


Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.