General Question

try www.442.com or the other cutlass forums on the net

re: '68 Cutlass "S" with floor shift/buckets, why dont my new seats fit?" Find your vehicle trim tag. Its a small silver sheet metal thing about 2 1/2" x 5" and is attached to the body by two sheet metal screws. I think its located below the windhield on the passenger side of the car under the hood(open) near the rubber cowl seal, below the wiper arm. On it is a series of #'s and letters in various sequence(s). It usually starts with: ST then a # for manufacture like "3" then letters "AJ" for Cutlass then series like "37" then a sequencial build # then TR for trim (interior/exterior colors) "965" and a seat # like "AN65" then paint code #'s like 19 - 19 then some vinyl top # like "76Y" then some other #'s for mouldings and stuff like that. These numbers aren't going to match what you have(just an example), however if you put your trim tag info on this website I'll try to tell you what your car came with. With this info. you'll be able to get the correct parts that will match existing stuff or help you re-create what should have been.

Did you get my Frankenstein citty I'm WA state?

In WA state.... I had a 68 that got impounded and kept. It was a cutlass S crimson with metal fleck paint used to be blue. Had the center console and buckets out of a GTO ( slap shifter ). The rear end was a 3.07 out of a pontiac