I have Chrysler 300 2006. The check engine light is on and a error code U0164 was diagnosed. Does anyone know the problem and how to fix it? Thanks a lot!

I have Chrysler 300 2006. The check engine light is on and a error code U0164 was diagnosed. Does anyone know the problem and how to fix it? Thanks a lot! 2 Answers

error code: U0164

I have a 2007 Chrysler 300. One day the car is running fine. I put the key in the igntion and turn it and the radio and dash board lights go on. but the engine wont go on. I use my Autostart and the car starts right up. Can anyone pleae tell me what it could be . I thought it could be the Igntion Switch pin. 2 Answers

I have a 2007Chrysler 300. One day my car is fine. I get in my car I put the key in the igntion turn it on and the only thing that worked was the radio and the dash board lights.It would not start. ...

I have a 2014 chrysler 300. I work a lot and so have to sleep in my car somedays to get some sleep at all. Anyways, I went to sleep in my backseat today. As far as I know I did not leave any electronics on and car was powered off. When I awoke I unlocked the doors with my door unlock button on my driver's side door and got out. Didn't think anything because I do this 5 days a week. Now I don't know if it's a battery issue or what...my car will do absolutely nothing except allow me to pop the hood and the gas cap now. 2 Answers

Is it a battery issue you think? As far as I know I didn't leave anything on. My fobs won't do anything to my car. My windows won't operate.

I HAVE A 2008 CHRYSLER 300 my problem is when I go to turn on the car I turn the key and it don't start right away I have to hold the key a couple of seconds for it to turn on then I let the key go. 2 Answers

Sometimes I turn the key, it turns on quick ... Sometimes I turn the key ,hold it on a lil bit , and then let go,a couple seconds later it turns on what might the problem be ...is it a fuse , a s...

I have a Chrysler 300 touring with a 3.5 v6 when I start it and the engine is cold the check engine light will flash on and off and it runs very rough and has no power but when it warms up it runs fine I have had it scanned and it shows a Radom cylinder misfire. I have changed the 02 sensors the spark plugs the gas cap and the fuel pump and still has the same problem and from time to time when you go to start it it cranks several times before it starts. Does anyone have any idea what else it could be?? 5 Answers