Low injector voltage

Asked by Jul 13, 2017 at 12:28 PM about the 1980 Nissan 280ZX

Question type: Maintenance & Repair

I swapped a 280zx l28e into my Datsun
720. And have it hooked up about 95%
correct I believe. My injectors have the
power but it's too low for them to pulse
correctly. What would cause this voltage
or ohms drop. Seems to be a common
problem really wish someone was a pro
on these.

2 Answers


You may have an injector with high resistance, disconnect the injectors and recheck the voltage, if it is still low then start tracing the power wire back until you find the bad spot. If it goes back up then start ohming the injectors till you find the one or more causing the problems.

I tried chasing it and we got injector pulse lights to check and the voltage is staying around 2.5 needs to be around 3.5. I'm going to trace the hot wire

Your Answer:


Nissan 280ZX Experts

  • #1
  • #2
  • #3
View All

Related Models For Sale

Used Ford Mustang
35 Great Deals out of 1,236 listings starting at $3,995
Used Chevrolet Camaro
9 Great Deals out of 946 listings starting at $11,500
Used Toyota Supra
2 listings
Used Mazda RX-7
2 listings
Used Dodge Challenger
24 Great Deals out of 980 listings starting at $10,000

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.