Triumph Questions Any type
- Recently Active
Your system is not recognizing my VIN. I previously listed with you in Massachusetts
I would like help finding a Canley intake manifold (part # 308087). Places I've found that have sold it indicate "no longer available". Thanks.
Hello. I had a great running Tr7 until I ran the gas low in the tank; gauge was not working correctly, wanted to see if it matched up to the gas in the tank. After I ran the gas low, I picked up ...
I'm trying to list a vehicle, but can not complete the listing as the prompts keep asking for VIN or plate. Every time I list either, I am still asked to add vin or plate. meantime, the tabs say...
Dropped a valve on a TR6 2495cc, It destroyed the piston and gouged the cylinder. Can I replace or repair the cylinder sleve?
Are the TR6 engines sleeved and can one be sleeved?
car runs good for aprox 20miles then jerks and stops leave sitting for hour starts and runs good again?
pedal goes to the floor but fluid is fine.
The fuel pump probably has Whitworth threads on the inlet. The compression fitting is standard. Fuel slowly seeps out from the fitting. Is there any source for Whitworth threaded compression fitt...
My TR6 shows signs of poor performance as I shift through each gear when the RPM is between 2200 and 2400. In any gear with the RPM higher than 2400 performance is normal. The car has an electroni...
steel plate with bent flanges and a round steel tube on it rattles ..it is above the catalitic converter but is not attached to it.. it wraps around the exhaust pipe above converter and is not attac...
I want a higher top end speed. I believe the final drive that's in it is a 4:11. I have an additional rear end with FK30859 stamped on it but can't find that designation anywhere. What is it?
I have 1974 triumph tr6 I drive for about 20 minutes and. It chokes and dies then it won't start ????
Engine is misfiring and number 3 cyl plug is black ( fuel fouled) I have replaced wires, plugs, etc. compression is 115 +/- 3lbs in all cylinders. Why is number three acting up?
triumph tr6, 1974, in good condition, needs carbs over hauled and tlc
So I recently replaced the starter solenoid and coil pack on it and ran fine for 3 miles and then had a ton of carburetor issues where it seems like it's not getting enough fuel so I replace the fu...
Car runs great! However when I take it on long runs and come to a stop sign the idle wants to go down until the car stalls. The car is NOT over heating. All lines have been insulated with 2000 degre...
Search Triumph Questions
Find great deals from top-rated dealersTMSearch
Triumph Model Question Topics
Popular Cars for Sale