Oldsmobile Silhouette Questions Maintenance & Repair
99 Silhouette Wont Start. Pressure At Fuel Rail, Will Fire With Starting Fl...
won't start. ran fine night before. turns over, has spark, good flow at fuel rail. obd2 says no codes... new fuel filter. will fire on starting fluid. seems to not be injecting or calling for fuel... ...
ABS Traction Contr
Just replaced the abs control module on my 2002 Silhouette. light was off for a week. I had a flat tire. I when i changed to the donut, my abs trac light came back on. Does changing the wheel cause th...
Drl (daylight Running Lights)
Daylight running lights stays on draining battery. any ideas?
Car Stalled Out On Me And Won't Start Will Crank But Wont Start
I left planet fitness turn the wheel hard car shut off then it restarted, abour 1/8 of a mile it shut off quietly for the second time,then I change the sparks pugs,wires,and fuel filter,still won't st...
How To Remove The Crossover Exhaust Pipe In An Oldsmobile Silhouette 1998
How to remove the crossover exhaust pipe in an Oldsmobile silhouette 1998 to reach the thermostat? Problem: It seems like it is very difficult to reach and remove the heat shield bolts in the rear sid...
I Have A 1997 Lods Van,and The Eng,light Came On,put Plugs And Selder But S...
said the 3d selder was not fiaring and needie plugs put new ones on but the light is stell on and stell runing bad,what do you thank?what could it be? thanks.
Body Decomposition
I have a 2001 Silhouette GLS - and live in a rather difficult climate to keep it presitine, with the amount of road salt used during the winters. This year seemed preticularly bad for rust appearing ...
Headlights And Interior Lights Flicker?
Hello, My headlights and interior lights dim slightly and then return to normal, in idle, in park and when you step on the brakes. If you have it in park and give it gas, then they won't dim, but once...
Rear Washer
where do i fill the rear washer
Grinding Left Front When Backing And Turning
Grinding only occurs when vehicle is in Reverse and you are turning the wheel. Grinding is coming from the brake disk/pads as scratches can be seen in the disk. I have replaced both wheel bearings an...
Starter Doesn't Seem To "release" And Causes A Loud Grinding Noise For A Se...
Dealership replaced starter...no change...sounds like the starter motor gear is not dis-engaging from the fly wheel for a brief moment...makes loud screeching noise for a second or two...didn't do it ...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.