Mazda Questions Maintenance & Repair
Is There A Way To DIY A Ruined Logo On A Steering Wheel?
How do I go about fixing or covering the logo with a chrome or silver like paint pen? Or do I have to get it replaced?
How Do I Fix This Scratch On My Bumper And How Much Will It Cost? DIY??
Wondering how to fix this scratch or if it totally needs to be sent to a shop
Can Someone Help With My Car ?
Motor in good condition and has only 120k. The transmission has to be shifted manually from first to second,the drive has gone out but new solenoids have been installed any idea what the problem c...
Do I Need To Add Coolant To My Radiator?
Just wondering, cause my reservoir is empty so i was just gonna fill it up but people are saying i might have to put coolant in the radiator, just wanna know what to do?
My Left High Beam Won't Work?
My lowbeams work fine both of them, but when I put my high beams on the left one doesn't work. What should I do?
Mazda CX-5 Grand Touring SUV
sometimes when I turn off the engine the accessories stay on and can run down the battery. Why?
How To Replace Main Fuse 2008 Mazda 3
Installed battery backwards, now won’t start. Swapped around the starter and main relay with heater relay, still nothing. Main starter fuse is next, which is bolted to the positive terminal. Just ...
Car Slows Down When Going Uphill.
My car slows down when going uphill. No jerking. Just looses speed. Changed the TCM. No problem with it on straight road.
Where Is The 'Vehicle Speed Sensor' Located On This Vehicle With ABS?
all the dash lights came on simultaneously, speedometer showed 0 but still running. stayed in 3rd gear and wouldn't change. limped back home and plugged in the FIXD diagnostic which said Vehicle spe...
Why Wont My Rx8 Stay On
I was on my way to the gas station when my RX8 Started to sputter I thought it was because I needed gas But after I put gas it's still did it I got it home tried to start it again and it wouldn't s...
Hydraulic Clutch Line
I replaced the master cylinder as well as the clutch hose and about 3 years ago replaced the slave cylinder but now the clutch is sticking and when I press it too hard the clutch hose pops out of t...
Anti-theft Lockout Mazda 6 2010
How do I reset the Anti-theft lockout?
Mazda B2200 Same Parts
I have a 1992 mazda b2200 and the exhaust system is gone and was wondering if a 1992 nissan trucks exhaust system would bolt on to the mazda? Would i have to do some tinkering to get it to fit?
2011 Mazda3 Intermittent No Start/no Crank
Intermittently will not start or crank. Lights come on. Will usually start eventually within 15 minutes. No codes. Have tried moving shifter to neutral, passing through gears and back into park or ...
My Tail Lights Won't Work On My 2008 I Have Replaced The Taillights Already...
2008 Mazda 3 tail lights
What Makes A Car Not Turn Over If It Has Fire And Fuel Pressure
Cranks but wont turn over code was up fuel rail sensor going down highway car stalled tow home changed fuel rail sensor no start only a clunk noise at fuel pump so I changed it and the fuel filter...
Mazda Mpv Overreacts To Turning The Steering Wheel
Why does my minivan seem to veer from one direction to another when in making the smallest movement of the steering wheel
Mazda 3 Sounds Like It Is Starting And Then Dies. What Wrong?
Out of the blue my Mazda 3 won’t start. I turn the key it sounds like it is starting and then it just dies. It never gets to the point of actually running. At terry seems fine. It cranks and cranks...
Automatic Car Jerking
Mazda axella (Mazda 3) 2.0L 2007 model (automatic) started jerking as I was driving,in fact the jerking happens after the battery light flashes on and off,what should I do?
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.