Ford Ranger Questions Any type
Oil Pressure, Amp, And Temp Gauge
I'm trying to install an aftermarket Oil Pressure, Amp, and Temp Gauge in my 1986 ford ranger 2.9L V6. I've installed the temp just fine. The oil pressure guage I CAN NOT figure out where to put in my...
2007 Ranger SportTransmission Problem
I have had a problem with the Trans at 400kms it started to slip.From a stop if you take off it will rev up then slam in gear.Revers seems to be worse.The dealer can not duplicate the problem so they...
Rear Door Speaker Removal
I was wondering how you remove the rear door speakers, i see no screws, tried popin it off and that does not work either. Is there a special tool or am i just missing something that makes it easy. The...
Replacing Rear Transmion Seal On 93 Ford Ranger
I have a 93 Ranger with a M50D-R1 5 Spd can you replace the rear seal from the outsid with a seal puller?
My Entire Truck Has Power, The Radio Works Thelights,ect ,ect) The Starter ...
the truck has power the battery has 12.5 ohms i think the lights in the truck work and are on the radio is on and all the head lights and brake lights work when i go to start it is dose nothing the s...
What All Do You Have To Do To Put A 302 In A Ranger Will It Bolt Up To A 2....
i was woundering if any one had iformation on how to put a 302 in a Ranger or bronco 2
I Am Working On Replacing My Engine In My 2000 Ford Ranger And Was Wonderin...
My 3.0L went bad and was wanting to upgrade. I was wondering if the parts are interchangeble like they were back when the carberated engine was out.
Engine Questions
will parts from a 3.0L engine work on a 4.0L crate engine? i was wondering
I Can't Locate The Starter On My 1991 Ford Ranger. Can You Help Me? Is It H...
I can't locate the starter on my 1991 ford ranger. Can you help me? Is it hard to replace? I bought a new starter and feel like an idiot that I can't even find the old starter in order to replace it. ...
Removal Of Ignition Pack On Rear Of Distributor? What Type Of Heads Do The ...
I do not want to pull the distributor...I cannot see the screw heads and need to know what type of tool I need.
How To Install Rear Speakers In 2007 Ford Ranger Xlt
how to install rear speakers
Removal Of Ignition Pack.
What type of head is on the machine screws. I can access them but cannot see the head to know what type of tool to use.
Which Fuse Is For Brake Lights?
I have already checked brake switch and that did not solve problem. I am unable to locate my owner's manual. Please help!
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.