MGM_Mobile_Electroni... answered 5 years ago
You may want to make your own, if you're having trouble locating the factory grounds. I'd recommend cleaning an area with a wire brush and using a self-tapping screw. Most cars have ground points on the front left or right fender but i'm assuming the points are not visible/ obvious. I can do more checking if you're determined to use a factory ground location. Hope this helps.
Looking to connect a ground wire for a HID kit near the driver side headlight. Where are the ground locations?
2015 Ford Explorer XLT
-
General
Will a manual seat work for an explorer that has electric power seats
1999 Ford Explorer
-
General
Will parts like windows, Headlight an taillight from a 1996 Ford explorer fit for a 2006 Ford explorer.
2006 Ford Explorer Eddie Bauer V6 4WD
-
General
Whenever I have my low beams turned on only my driver side headlight flickers. I didn't figure it could be a alternator/battery problem due to it just being one.
2016 Ford Explorer XLT 4WD
-
Maintenance & Repair
I have a 2004 Ford explorer the CV joint in the front is gone can I still drive it
2004 Ford Explorer XLT Sport V6 4WD
-
General
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.