It should be close to the frame rail Driver side near engine.
Yes, that is the location, I just changed one, they can be difficult not a lot of room. Make sure you start the clips properly if you don't you will have a problem.
gemini_2760 answered 7 years ago
Yes, I have replaced the filter but im trying to find the second fuel pump?
1987 Ford Ranger XLT Standard Cab 4WD SB
-
Maintenance & Repair
When i run my ranger for very long at speeds of 45 to 70 I have a valve that start pecking realy bad if i let it idle for a while it will stop. This motor has set for a while could it need new lifters...
1987 Ford Ranger
-
Maintenance & Repair
Truck shut off pulling out of my driveway we have checked the distributor, pickup coil, ignition module, coil , distributor cap and still no fire it will turn over but that’s all
1987 Ford Ranger
-
Maintenance & Repair
I need a diagram to show me where the FUSE/RELAY for 4WD is on a 2001 Ford Ranger
2001 Ford Ranger Edge Plus 2 Door Stepside 4WD
-
Maintenance & Repair
I have a 1987 ford ranger 4x4 with the electronic touch drive 4x4. the touch drive lights are really dim when you turn the key on, i think the touch drive is broken, is there a cheap way to bypass the...
1987 Ford Ranger
-
Maintenance & Repair
CarGurus has 701 nationwide Ranger listings starting at $8,800.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.