Pulling motor and transmission together

10

Asked by Jun 09, 2017 at 07:45 PM about the 1988 Ford Bronco II STD 4WD

Question type: Maintenance & Repair

Motor is shot on my 88 bronco 2 and we have no
clue if the transmission(automatic) is any good so
I was wondering if itd be easier to remove both at
the same time and if so how? I have a shop i would
bring the tranny to once I'd get it out. Motor is
basically stripped besides the fuel lines, my
biggest thing that I'm unsure of(other then pulling
it all together) is how to remove the shifter,
unplugging the harness from the transmission and
removing it from the transfer case. Thanks in
advance!

2 Answers

69,385

Yes, it'll be easier to pull both the engine and transmission assemblies together. You may have to jack up the front of the vehicle so the transmission tail will clear the floor as you lift the units up and out of the vehicle. You'll want to remove the radiator for increased forward clearance. HTH. -Jim

1 of 1 people found this helpful.
10

Okay Thank you and do you know how to remove the shifter, and unplug the wire to the transmission? And disconnecting from the transfer case?

Your Answer

Shortcuts

Ford Bronco II Experts

  • #1
    tennisshoes
    Reputation
    590
  • #2
    Andrew Olsen
    Reputation
    230
  • #3
    Colin Rivet
    Reputation
    220
View All

Related Models For Sale

Used Ford Bronco
2 listings
Used Ford Ranger
62 Great Deals out of 335 listings starting at $3,900
Used Ford F-150
459 Great Deals out of 9,063 listings starting at $922
Used Jeep Wrangler
91 Great Deals out of 1,586 listings starting at $2,488
Used Ford Mustang
9 Great Deals out of 1,191 listings starting at $2,995
Used Chevrolet Blazer
14 listings starting at $1,750
Used Chevrolet Camaro
796 listings starting at $10,000
Used Ford F-250
5 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.