I have no brake pressure I replaced the caliper first then master cylinder and now break booster bleed the brakes dozen times still nothing. What am I missing??
I was changing my drivers side bearing I busted the caliper taking it off so I replaced the caliper then I had no brake pressure so I noticed a small leak on the master cylinder so I then replaced that, still no break pressure still very spungy going all the way to the floor so then I change the brake booster and bleed the brakes a hole lot more still no pressure. Never had any brake problems before, not sure if im missing something little any Ideas??
Sounds like you might still have some air in it. Also make sure the bleeder is closed before your helper lets up on the brake pedal. Make sure to keep resivoir full of brake fluid while you are bleeding them.
Yup that's exactly what were doing still nothing no leaks anywhere just cant figure this out haha
I'm having the same issue so what did you finally find
Why do my brakes doint pump up
Check for small pinholes, I just had the same problem here it was a tiny pinhole right behind the drivers front wheel at the junction. Photo is the leaking spot.
