There are 3 plastic finger screws in the trunk that hold the whole assembly on.There are 2 on top straight across from each other and one on the bottom. The 2 inside screws also double as the hooks for holding the netting and the top outside one is tucked back in the corner more. Really easy.... good luck.
show me how to Replace the Tail Light on the passenger side
2004 Chrysler 300M FWD
-
Maintenance & Repair
I just recently had the engine block crack in my 2002 300m. So now I'm looking for a replacement engine. I live in San Antonio and can't seem to find one. Can anyone help me find one or one that will ...
2002 Chrysler 300M
-
Maintenance & Repair
My check engine light keeps blinking when I get between 40 and 50 mph and shakes between that speed. When I take it to AutoZone and they scan it the code is p0204 and P0304 I've changed the spark ...
2000 Chrysler 300M
-
Maintenance & Repair
My car did run hot an cut off . We have replaced the thermostat water pump it had a bubble we fixed that . Now the service engine light is on sometimes it blinks and it is running very rough map s...
2002 Chrysler 300M Special FWD
-
Maintenance & Repair
The brake light came on in my 2000 Chrysler 300. I checked the parking brake, the fluid and there is no hard code set.
2000 Chrysler 300M FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.