How do I reset the ECM after recharging?

Asked by obergg1 Mar 12, 2016 at 09:17 AM about the 1993 Cadillac Allante FWD

Question type: Maintenance & Repair

The message"A/C low refrigerant" still displays and the compressor worn't
run. I know the compressor is good because the mechanic jumpered it,

10

apostile2002 answered 8 years ago

Try disconnecting battery and then reconnect.

1 people found this helpful.

Mark helpful

Your Answer:

How do I reset the ECM after recharging? 1 Answer

The message"A/C low refrigerant" still displays and the compressor worn't run. I know the compressor is good because the mechanic jumpered it,

1993 Cadillac Allante FWD

-

Maintenance & Repair
where is trhe fuse to reset the anti theft on 1992 allante 2 Answers

where is the ECM/ECU fuse to reset the anti theft on 1992 allante

1992 Cadillac Allante FWD

-

Maintenance & Repair
My 1990 Alantee acts like it is not getting gas. I can shoot starting fluid in the air filter and the car runs fine until the fluid burns out. I checked the fuses in the center console and they are OK. This happened after the security system went off as a result of me changing a dead battery. I was wondering if there are 2 possibilities preventing the car from running. 1 â Did the factory security system cause my fuel pump to deactivate? And do I need to reset it??? Or 2 â could I have blown a fuse someplace when I changed batteries? I suspect the fuel pump has no power because when I turn the key, I can not hear the pump. Thanks for your comment on this question. 10 Answers

My 1990 Alantee acts like it is not getting gas. I can shoot starting fluid in the air filter and the car runs fine until the fluid burns out. I checked the fuses in the center console and they are ...

1990 Cadillac Allante FWD

-

Maintenance & Repair
I jumped start my car and the positive cable got loose and grounded out. Did I blow out a guise or breaker? It won't start now. 2 Answers

My car had been parked for about a year when I tryed to jump start it. The positive cable became loose and grounded out. The car will not start even with a new battery. Did in low a fuse or breaker?...

1989 Cadillac Allante

-

Maintenance & Repair
door is hard to close. How do I repair? 1 Answer

The drivers door does not close properly requires a lot of force to close. How can it be adjusted?

1991 Cadillac Allante FWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.