need to replace oil inlet stripped hex on super charger

Asked by Mar 21, 2017 at 11:35 PM about the 1996 Buick Park Avenue 4 Dr Ultra Supercharged Sedan

Question type: Maintenance & Repair

super charger cone oil  "refill hole"  has a stripped hex and can not be backed out. Any suggestions ???

2 Answers

1,390

If it were mine (I happen to have a wire feed welder) I would tack weld the hex wrench in the wrench hole....that would allow you to turn and pull at the same time. I think that plug has an "o" ring so you could carefully put in a Helicoil or maybe one of those rubber pan plugs.

Best Answer Mark helpful

Thank you. I did it with JB cold weld, worked great and easy for future use also. you are the best ! Knight

Your Answer

Buick Park Avenue Experts

  • #1
    Jking1838
    Reputation
    1,080
  • #2
    Tom Demyan
    Reputation
    760
  • #2
    jateen29
    Reputation
    760
View All

Related Models For Sale

Used Buick LeSabre
16 listings starting at $1,400
Used Chevrolet Impala
61 Great Deals out of 932 listings starting at $1,900
Used Buick Regal
324 listings starting at $9,495
Used Buick Century
18 listings
Used Lincoln Town Car
13 listings starting at $1,850
Used Toyota Camry
42 Great Deals out of 1,590 listings starting at $1,700
Used Chevrolet Tahoe
7 Great Deals out of 633 listings starting at $6,871

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.