Wheel seal rubs on the spindle and the spindle lock nut loosens up. Does anyone know why this happens?

Asked by Merida Sep 28, 2010 at 12:50 PM about the 1992 Chrysler Town & Country LWB FWD

Question type: Maintenance & Repair

i replaced the rear wheel bearings on my 1992 town and country 2 wheel drive.

after i replaced the wheel bearings i noticed that the van will shake while driving. i lifted the van and noticed the the wheel was loose. i removed the tire and noticed that the nut was loose. why does the nut loosen up? i also noticed that the wheel seal rubs on the spindle and basically grinned the seal off. can anyone tell me if there should be a spacer there? or did something break?

thank you in advance.
Jimmy

1 Answer

Jeff answered 13 years ago

Jimmy the wheel spindles either have a hole in them that a pin goes through, or you take a chisel and hit the corner of the bolt to distort it. out of curiosity, does the original bolt have a mark where it was struck previously? if so get a new bolt, they are designed to be used only once.

Mark helpful

Your Answer:

Related Questions

Shortcuts

Search Chrysler Town & Country Questions

CarGurus Experts

  • #1
    Lisa Klancher
    Reputation
    3,580
  • #2
    dandyoun
    Reputation
    3,280
  • #3
    thejeepdoctor
    Reputation
    3,160
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Dodge Grand Caravan
128 Great Deals out of 2,006 listings starting at $2,995
Used Ford Explorer
58 Great Deals out of 2,040 listings starting at $6,990
Used Ford F-150
310 Great Deals out of 13,812 listings starting at $3,800

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.