Limp mode?

Asked by Jose Sep 21, 2016 at 10:35 AM about the 1994 Chrysler Town & Country LWB FWD

Question type: Maintenance & Repair

Sometimes when I start to drive
transmission wont go past second
gear only sometimes

3 Answers
101,755

KenF answered 7 years ago

Limp mode should reset after every cycle (engine restart), if it finds the same condition it will reset limp mode. It locks you into second gear. You can check trans fluid and the EATX fuse & relay to start with, typically you'd have to run the Chrysler DRB scan tool to find a cause. (Could be it needs a new solenoid pack, but could be any number of bad connections between the trans control module and sensors.) FYI most transmission problems won't appear as a trouble code in OBDI or OBDII system.

15 people found this helpful.
Mark helpful
210

servergms answered 6 years ago

09 chrysler town country transmission limp mode reset. I replaced 2 sensors on the Transmission . I was told it only had 1 sensor but when I removed the 1st one I found the second one next to it. It has at least 5 speeds when I use the shift . Anyway, replaced both and now it only goes to limp mode and the engine light comes on. The engine light was not coming on before. i did all this cuz when i would play the radio or any other device the van would go into limp ode! plz advise? Regards Bob

21 people found this helpful.
Mark helpful
150

Mark answered 3 years ago

My 2005 Town and Country wouldn't shift in hot weather after driving a while, (P0700 code) so I went into the fuse box and replaced the EATX Safety Shut Down Relay for $20. Problem solved! Thanks, Occam's razor!

6 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • Car and limp mode can I take it out of limp mode 4 Answers

    My 2001 Town & Country is in limp mode it has a code 0755 shift cylinder B can I replace that and somehow take it out of limp mode and keep driving it

    2001 Chrysler Town & Country LXi LWB AWD

    -

    Maintenance & Repair

  • 2001 chrysler town&country limp mode 2 Answers

    fixing this problem often times turns into a money pit because of so many possible causes. There must be a way to override the limp mode and get the trans to shift into all gears. a 2001 van is wort...

    2001 Chrysler Town & Country Limited LWB FWD

    -

    Maintenance & Repair

  • Limp mode? 3 Answers

    Sometimes when I start to drive transmission wont go past second gear only sometimes

    1994 Chrysler Town & Country LWB FWD

    -

    Maintenance & Repair

  • Limp mode 3 Answers

    How to fix limp mode in 2007 chrysler 300

    2007 Chrysler 300 Touring RWD

    -

    Maintenance & Repair

  • Limp Mode ??? 2 Answers

    Car goes into limp mode for 1minute or 2 then runs fine for a wile then does it again

    2003 Chrysler PT Cruiser GT Wagon FWD

    -

    Maintenance & Repair

Town & Country

Looking for a Used Town & Country in your area?

CarGurus has 114 nationwide Town & Country listings starting at $5,987.

Postal Code:

Shortcuts

Search Chrysler Town & Country Questions

CarGurus Experts

  • #1
    Lisa Klancher
    Reputation
    3,590
  • #2
    dandyoun
    Reputation
    3,280
  • #3
    thejeepdoctor
    Reputation
    3,160
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Dodge Grand Caravan
131 Great Deals out of 1,980 listings starting at $3,950
Used Honda Odyssey
46 Great Deals out of 840 listings starting at $1,999
Used Ford Explorer
62 Great Deals out of 1,787 listings starting at $2,888
Used Ford F-150
279 Great Deals out of 14,067 listings starting at $3,888
Used Nissan Quest
16 listings starting at $4,980

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.