> 05 Suburban Ac Only Thru Defrost Vents & Hot Only On Driver Side, 05 Suburban AC only thru defrost vents & hot only on driver side

Asked by rjatherton Jan 27, 2011 at 10:45 PM about the 2005 Chevrolet Suburban 1500 LS RWD

Question type: Maintenance & Repair

2005 Suburban 1500 w/dual-zone manual (non-digital) adjustment

Problem started with cold air only on driver's side, passenger side fine. I should add that at this time the mode switching was working fine.

Found a post with a similar issue and followed the instructions. Now the issues have gotten worse.

Steps I took:
(1) Found blend acuator on driver's side. disconnected, removed, clean-up and re-greased. plugged in without installing to make sure it worked. The little cogs turned when powered up and things seemed to be working fine. Still had issue with only blowing cold, but mode switching stilled worked.

(2) Located acuator on passenger side under the dash. Pulled it, cleaned and re-greased. Plugged into the driver's side to test the acuator with power. The little cogs turned and then stopped. Should mean that it is good, right? Re-installed and tried the re-calibration steps (hold a/c button 5 sec, ....) The driver side is now blowing hot and the mode switching does not work - it is stuck on the defrost vent

With both acuators working originally, I thought it might be the control box so I replaced it. The lights were all burned out anyway. This was not the problem, obvioulsy, so I am back to square one.

I have tried taking the 10 amp hvac fuse under the hood and let it re-calibrate, but with no success.

Sorry for the long post and I hope I provided enough detail where I might get some help. Thanks in advance.

1 Answer

19,925

You are probably going to need both actuators at this point. They sound like they now have over run their max positions Make sure the BOX is not damaged . Heat up the vehicle with both motors out and disconnected. Reach in and Turn the actuators MANUALLY ( By Hand ) and see if you can change from hot to cold on both sides. If everything works by hand then we know its actuator problems. When you get them new you will see they are lined up in a default center position. Install them into the box with the flaps in their center position. After everything is in installed in the center position, then do the alignment routine, recalibrate as directed Good Luck

2 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Andrew Olsen
    Reputation
    3,080
  • #2
    JimO65
    Reputation
    2,390
  • #3
    Rowefast
    Reputation
    2,130
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used GMC Yukon XL
17 Great Deals out of 722 listings starting at $11,500
Used Chevrolet Tahoe
13 Great Deals out of 822 listings starting at $9,980
Used Ford Expedition
19 Great Deals out of 669 listings starting at $7,894
Used GMC Yukon
14 Great Deals out of 981 listings starting at $3,000
Used Cadillac Escalade ESV
10 Great Deals out of 156 listings starting at $9,487
Used Cadillac Escalade
16 Great Deals out of 498 listings starting at $5,000
Used Chevrolet Silverado 1500
214 Great Deals out of 8,009 listings starting at $1,500
Used Lincoln Navigator
8 Great Deals out of 314 listings starting at $18,909
Used Toyota Sequoia
3 Great Deals out of 56 listings starting at $19,990
Used Ford F-150
314 Great Deals out of 13,742 listings starting at $3,800
Used Chevrolet Silverado 2500HD
33 Great Deals out of 1,683 listings starting at $3,000
Used GMC Sierra 1500
132 Great Deals out of 8,251 listings starting at $3,000
Used Dodge Durango
51 Great Deals out of 1,897 listings starting at $6,987
Used Toyota Sienna
47 Great Deals out of 631 listings starting at $2,499

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.