Can you Replace a dana front axle with 3.73 gears with cv joints with a dana axle with 3.73 gears with u joints if I change to a u joint drive shaft.
Quadra Trac awd
Asked by CanadaJeep Feb 28, 2015 at 07:02 AM about the 1997 Jeep Grand Cherokee Laredo 4WD
Question type: Maintenance & Repair
Quadra Trac awd
yes the housing and the side gears did not change they just updated the axles shafts and front drive shaft ..// you will just have to check to make sure the mounting points are the same as well as the knuckles ...// is the diff bad (gears ,bearings) or is the housing bent
Quadra Trac awd
1997 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
The front diff just went out in my 95 Grand Cherokee limited. Can I disconnect it and still drive it in 2 wd?
1995 Jeep Grand Cherokee Limited 4WD
-
Maintenance & Repair
ball joints question
2003 Jeep Grand Cherokee Limited 4WD
-
Maintenance & Repair
AC hose busted after being maneuvered around to get bolts out, Can it still be driven while it is broken?
2001 Jeep Grand Cherokee Laredo
-
Maintenance & Repair
1995 Grand Cherokee Limited AWE with np249 mTC
1995 Jeep Grand Cherokee Limited 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.