Spongy brakes
I just put new pads on my car now my brake pedel goes to the floor and is very spongy.
Have bleed all the lines with no bubbles. Any ideas?
Bleed the entire brake system and when you do this,always start with the bleeder valve farthest from the master cylinder. Also bleed the baster cylinder first. http://www.wikihow.com/Bleed-Car-Brakes http://www.caranddriver.com/features/how-to-bleed-your-brakes-feature/ Do it right and do it once Bob Lech
I just put new pads on my car now my brake pedel goes to the floor and is very spongy. Have bleed all the lines with no bubbles. Any ideas?
2001 Ford Explorer Sport 4WD
-
Maintenance & Repair
The front blinkers work and blink at normal pace but in the back, both left and right lights blink at the same time. And when I push on the brakes the blinker just stops and the light just stays on an...
2002 Ford Explorer Sport 2WD
-
Maintenance & Repair
I was driving and my od light started flashing. Then not even 5 min later I lost acceleration. If I park the vehicle and restart it I can drive until I stop then no acceleration again. I do not k...
2001 Ford Explorer Sport 2WD
-
Maintenance & Repair
When ABS light is off it brakes normally till the last few feet and then gives out for a few seconds but still brakes barely. ABS light is on it brakes good all the time. When it does that it pulls...
2002 Ford Explorer Sport 4WD
-
Maintenance & Repair
My '12 Equinox has spongy brakes. No leaks anywhere. Master cylinder has clean full level. Booster & vacuum check valve are working well. Could I have a bad ABS module or as simple as air in lines...
2012 Chevrolet Equinox LS FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.