2010 Ford F150 rear lights are not working
Rear lights, brake lights, turn signals,
reverse lights and hazards not working.
Also license plate lights. The only light in
the back of the car that works is the
cargo light. All front lights work including
hazards. The fuses look fine I checked
lots of them anything having to do with
lights. I checked electric connections as I
followed the wire bundle up to the fuse
box I didn't see any that seemed lose or
in poor condition. The only one that
looked warn was above the spare tire,
but it seems to make connection and the
pins look OK. I checked most of the
bulbs they're fine so far but could one
faulty bulb cause this? What am I
No, one bulb would not affect the rest of the bulbs. Could be a ground problem in the back.
Also check for the fuse number which controls the rear lights. Use a multi meter and check for voltage inside the fuse box where the fuse plugs into.
I'll check for power at the box today.
So there's power at the rear lights, and all the bulbs we've checked are good. I plugged the lights into the front fixtures and they work there.
Use a multi-meter or a 12 volt circuit tester with a light to check for power to the light sockets in the rear. Check inside the socket (where the light makes contact with socket and also at the rear of the bulb sockets where the wires enter the socket. Sockets are known to go bad. Although since all the lights are out I believe the problem may be with the ground. Find the ground location for the rear lights and check for a good contact. You can also check the ground with a multi meter. The new will have a video to show you how.
Correction, the NET will have a video to show how.
Thanks, the ground seems to be the next most likely option. Argh I did use a multi-meter it red a bit over 12 volts at all the light sockets, it also confirmed that the blinker relays work fine.
If you're reading 12 volts at the socket with a multi-meter, then the problem is with the ground, if you touched a metal part of the vehicle while contacting the lead inside the socket. If you have problem locating where the tail lights ground, let me know. I have a color coded wiring diagram around the house somewhere for the 2010 F 150.
I cleaned the two grounds in the back, although they seemed OK to me. One was above the spare tire, the other was near the drivers side rear tire, it was connected to a electrical connector with six other wires out of the rear bundle. I assume they are all grounds. It has this inline (see photo) they appear to be thicker copper wires that have been partially exposed at some point. When I do the oms test on either side of it, the reading continually changes and zeros every now and then. I put a jumper wire around it, bypassing it to see if it was the problem but still no luck. I'm hesitate to cut it off and replace it with wire because I don't know what it is.
The larger wire appears to be a ground. Black wires are ground wires, if someone didn't begin splicing things together haphazard. The solid black wire coming off the plugs for the tail lights is the ground. The multi colored wires should be the power side. Try to trace them and see if they lead to the plug you have in the photo. Backprobe at the tail light socket with the headlights on to determine which wire is the taillight. Use the ground probe on a metal portion of the vehicle. If you have power going to the socket, but no lights, since all are out, you will have to find where the ground is broken.
From viewing the photo there seems to be a broken black wire. Has it been pulled out of the socket/cut?
Attaching a copy of the tail light wiring diagram for 2010 F 150. Ground is not solid black, but black/green. If you have difficulty reading the codes I can send to you by other means if you wish
I'm not sure what to make of that, I've never used wiring diagrams before. The frayed wire you see is braided steel I think it's added to the bundle for strength but I could be wrong I don't see any broken wires.
Ask around of your friends or relatives. Anyone with basic electrical knowledge should be able to locate the problem within minutes.
I appreciate the help! It looks simple enough I'm going to try to muddle my way through it.
Fixed! Man thanks for all the help OJ! Even though I can't really tell what the numbers and symbols mean that diagram led to the fix by showing me which wire top follow. It ended up being the burned ground connection in this connector. I found it at the rear most part of the underside of the truck bed. It was nicely concealed in a cavity that the tail light wires run through. There was very little slack on the wire bundle to work with. The burned pin you see in the connector is the black green ground wire.
I had the same problem and the black/green wire that goes to the rear under the spare tire was bad.
So do you just replace the connector and attach new wires to all of them
I just replaced the one wire and bypassed the connector.
Looking for a Used F-150 in your area?
CarGurus has 9,753 nationwide F-150 listings starting at $995.
Search Ford F-150 Questions
Ford F-150 Experts
Related Models For Sale