My 2010 ford bantam 1,3i speedometer dont work nd the fuelguage needle moves up nd down

Asked by Oct 18, 2014 at 12:33 PM about the Ford Bantam

Question type: Shopping & Pricing

2010 bantam,1,3i rocam

2 Answers

102,385

Check fuse,s,and speed sensor,all so check for loose ground wire,s.

7 people found this helpful.
3,595

To check the cluster, Perform a cluster check on these vehicles. Ignition OFF. ODO trip button in and hold it there. Ignition to the ON (II) position and wait till the LCDs on the ODO display TEST. release and press the trip button in and the speedo needle will sweep Full and back to Zero, Carry on and press the trip button in and check the Rev Counter, The Temp and fuel gauges, LEDs, LCDS, Ect. When the engine idles. Every seven seconds if there is a slight miss. This indicates there is a harness problem between the PCM and the cluster. Check for an open circuit or plug connection between the PCM and Cluster

2 people found this helpful.

Your Answer:

Shortcuts

Ford Bantam Experts

  • #1
    Guru97FK8
    Reputation
    3,160
  • #2
    Janus Welgemoed
    Reputation
    910
  • #3
    AB Zaviour
    Reputation
    810
View All

Find great deals from top-rated dealersTM

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.