my ford bantam 1.3 rocam engine

Asked by GuruGBS9P Aug 20, 2020 at 03:03 PM about the Ford Bantam

Question type: General

struggles to starts ,when it does it idles and then when the engine is warm it
switches off and then battles to start again ,i thought it was the fuel pump but its
working

1 Answer

16,485

If it cranks and then battles to start, Check that the starter selonoid cable is not running in the same plastic channel as the crank angle sensor. The high voltage from the selonoid cable induces a high voltage into the low voltage sensor wiring. Separate these two sets of wires. Check also the battery earth cable and the starter amperage draw on the main battery positive cable.

Your Answer:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,180
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,120
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.