Are all torx screws used on a 1993 E 150 the same size and what size would that be?

Asked by Chuck Mar 07, 2017 at 09:20 PM

Question type: Maintenance & Repair

I'm doing the rear left door latch assembly, as I don't own any star-bits, I
would like to know which one i would need to buy.

F_O_R answered 7 years ago

I doubt that they are all the same size. Do like Tom says and buy a set.

Mark helpful

Your Answer:

Are all torx screws used on a 1993 E 150 the same size and what size would that be? 1 Answer

I'm doing the rear left door latch assembly, as I don't own any star-bits, I would like to know which one i would need to buy.

Ford

-

Maintenance & Repair
what size screws are used to hold the condenser and points in place in my 1962 ranchero distributor? 2 Answers

rebuilding my distributor and the screws for the points and condenser are missing. need to know what size and thread,etc.

1962 Ford Falcon

-

Maintenance & Repair
What could be the problem with my f-150 that it won't start because the gauges on dashboard for temp,oil,speed,rpm,and fuel they are locked they won't move at all when turnig on the key 38 Answers

And because of that the truck won't even try to start until playing with the ignition switch back and fort and allowing it to cool off a little then the gauges start moving again and then truck st...

2003 Ford F-150

-

Maintenance & Repair
what size of a hex wrenchs are used on front brakes 2006 ford escapes 1 Answer

I have tried a 7mm, and a 9mm hex tool and they are too small

2006 Ford Escape

-

Maintenance & Repair
My 2008 Ford Escape AWD floor matts keep getting soaked. I thought I had fixed it by making sure the sunroof was closed properly, but it has continued. I have tried to figure out where this is coming from and finally after drying them out again I laid under the the vehicle and both on the drivers side in the middle of the front floor area and the passanger side there is a small hole about the size of a dine right in the middle. That would account for the water coming in after rain storms and such, but why would these two holes be there? Was there a drain area there with plugs and they are missing? Can I have a piece of metal welded over them? Don't know why they would be there. Doesn't seem to be a rust issue as it is frim all around these small holes. 7 Answers

Water leak on floors from underneath. There is a small hole size of a dime on both drivers side and passanger side underneath floor matts right in the middle of each. Can I have this repaired with a...

2008 Ford Escape Limited AWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.