I have a Ford Bronco II XLT 1990 4x4, 2.9L V6.

Asked by MelanaT May 04, 2015 at 10:08 PM about the 1990 Ford Bronco II

Question type: Maintenance & Repair

After  7-10 minutes of running, the engine starts to slow down. It seem as though the
engine is under a lot of pressure . Appreciate any suggestions. Thank you.

3 Answers
143,855

T_S_T answered 9 years ago

Check oil level,and all so check the tranny fluid,if it keeps doing this have the compression checked on the engine.

Mark helpful

GuruB24N1 answered 5 years ago

I have a ford bronco xlt 1991 it has a inline 6 all power cruise control 5 speed manual no rust lots of new parts i need to no what its going. For im going to be selling it or trade for dump truck can any body help me

Mark helpful

Your Answer:

Related Questions

  • I have a Ford Bronco II XLT 1990 4x4, 2.9L V6. 3 Answers

    After 7-10 minutes of running, the engine starts to slow down. It seem as though the engine is under a lot of pressure . Appreciate any suggestions. Thank you.

    1990 Ford Bronco II

    -

    Maintenance & Repair

  • 89 Ford bronco ii xlt won't start 1 Answer

    I have a 89 Ford bronco ii with a 2.9 l v6 I had a blown head gasket so I changed out the gaskets I did everything by the book I bought a Chilton's manual so I knew I wouldn't screw it up I follo...

    1989 Ford Bronco II XLT 4WD

    -

    Maintenance & Repair

  • 1990 Ford Bronco II Door lock/unlock relay 12 Answers

    All three automatic door locks on a 1990 Bronco II will unlock when the unlock switch is depressed on the driver's side door. However, none of the locks will lock when the lock switch is depressed. ...

    1990 Ford Bronco II 2 Dr Eddie Bauer 4WD SUV

    -

    Maintenance & Repair

  • I have a 88 Bronco II that won't start 5 Answers

    I have replaced a starter (burned-up) , start solenoid (old one stuck on), start switch.....after all this ....solenoid gets stuck on ....stays on after switch is turned off, even after ignition wire ...

    1988 Ford Bronco II Eddie Bauer 4WD

    -

    Maintenance & Repair

  • Ford Bronco II starting problems 1 Answer

    My 1986 Bronco II is having starting problems! I can pull the map sensor hose loose an it will start right up...but if you try to reconnect the hose it will die. If I start with the map sensor lo...

    1986 Ford Bronco II XLT

    -

    Maintenance & Repair

Bronco II

Looking for a Used Bronco II in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Ford Bronco II Questions

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    1,220
  • #2
    Colin Rivet
    Reputation
    240
  • #3
    Christopher Brownfield
    Reputation
    230
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Bronco
20 Great Deals out of 1,940 listings starting at $39,999
Used Ford F-150
311 Great Deals out of 13,911 listings starting at $3,888
Used Jeep Wrangler
144 Great Deals out of 5,952 listings starting at $2,995
Used Toyota Land Cruiser
12 listings starting at $41,990

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.