FORD BANTAM ROCAM ALTERNATOR, BATTERY STARTING PROBLEM.

125

Asked by Jul 11, 2019 at 03:12 AM about the 2006 Ford Bantam

Question type: Maintenance & Repair

Hi guys and gals! I have a Ford Bantam 2006 1.3. Little bit of history: I have
had her complete engine replaced approximately 4 years ago. I didn't do
much driving for 2 years due to the main reason that I am posting. I have had
the misfortune of taking my car to an idiot and the result is problems with the
starter motor (since bought a new one), the crankshaft sensor (since bought
a new one) and 4 alternators. My problem is that this idiot put some sort of
relay on my battery and once again my 4th alternator is not charging my
battery. Surely every alternator (tested and working before purchasing)
cannot be faulty once installed?! There is nothing wrong with my engine and
starter motor as when the battery is fully charged (externally done) she starts
and rides with no issues. I am at my wits end! Please somebody help me!

5 Answers

30

If the car is running and starting fine its not the starter thats youre issue, it sounds like youve spent a fair amount on alternators and id like to help make sure you wont have to buy one again, what it sounds like to me is you have a power leak somewhere, power (ethier) isn't properly getting to the alternator or isn't leaving the alternator, often times starter wiring goes along with alt wiring, try looking for unplugged wires, maybe even test the power going to and from the alternator

2 people found this helpful.
125

Thank you for answering. I shall do so in my lunch break and get back to you.

125

I'll be buying new fuses and I need a test light apparently. Will be getting one tomorrow. So no further update today. Thank you again for your assistance.

4,315

We've had them that the main starter cable has been the problem. The Amperage draw on the starte cable should be checked. Also check the starter selonoid cable is moved away from the crank angle sensor as this higher current will induce current on the crank angle sensor wire (which has a minute voltage) I test light should not be used. Rather a Multi Meter or Volt/Amp meter. The Altinater charging voltage is normally 13.5 volts

1 people found this helpful.

Gure97k8... Please help me... I just got my 2004 bantum 1.6i and it cranks, the pump is running nun stop, thers no spark and i recently discovered that the starter relay was bridge... I was wondering where are the wires to the relay come from so that i can track them down... And also the security light sumtyms is flashing nd the just lights constantly during cranking... Please help

Your Answer:

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Ford Bantam Experts

  • #1
    Guru97FK8
    Reputation
    3,790
  • #2
    Janus Welgemoed
    Reputation
    940
  • #3
    AB Zaviour
    Reputation
    820
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.