Diagnosing a Blower Motor
I have a 2013 Ford Explorer PI. The blower motor is
not operating. There is no air coming out of any of
the vents at any speed, but you can barely feel the
A/C and heat when the car is motion. I replaced the
main relay, labeled blower motor relay. I know there
is a TSB but can't seem to find any other info online
about this issue. Any advice?
Have you checked the blower setting switch in control assembly?
How do you suggest doing that?
It can be done by undoing wiring harness to it and crossing with paper clip to the four setting,s,but i think your blower motor may be bad,very seldom does the control assembly go bad.
Have you replaced the risitor?
That was the next piece I was gonna check.
Hi, did you figure out the problem? I am having the same issue.
I'm having the same issue, tested blower motor & know it works. When it's installed doesn't seem to get ground can that be a relay?
I am having the same kind of issue. I replaced the blower motor and the resistor. I tested blower motor it's good (also new) doesn't seem to get ground?
Does Ford Explorer have multiple blower motors my rear air vents are blowing but defrost and front vents not
Yes, our 2013 Ford explorer limited has a front (main) blower and a rear blower. If you have 2 separate controls (front & rear) that's a good indication it has a blower for both
There is also a fuse and relay for both. The owners manual has a diagram and label for both.
