Asked by Guru9L8MPN Sep 13, 2021 at 06:30 AM about the 2008 Chrysler Sebring Limited Convertible FWD
Question type: Maintenance & Repair
why do my car shut off when i put in in drive gear only ... there is no codes or
engine light
In addition to a code scan. Tune up, clean the intake system, idle control valve etc.
Guru9L8MPN answered 2 years ago
the car runs in park nutural and reverse i dont think it would run if the idle control vale was bad
Does my trunk shocks have to work in order to drop the top on my 2008 Chrysler Sebring?
2008 Chrysler Sebring Touring Convertible FWD
-
Maintenance & Repair
Hi all. I have an issue with the top of my 2008 Chrysler Sebring. It stucks in the middle of the operation when I try to open as sees in the picture. Always stucks in the same position. Any malfunc...
2008 Chrysler Sebring Touring Convertible FWD
-
Maintenance & Repair
My 2008 Chrysler Sebring would shake at random driving down road, then the breaks pedal finally just went limp all the way to floor never to stand tall again, replaced the break lines, checked rot...
2008 Chrysler Sebring
-
Maintenance & Repair
I HAVE A 2008 CHRYSLER SEBRING TOURING AND THE LIGHTING BOLT CAME ON. THE CAR RUNS NORMAL BUT I STILL NEED TO FIX THAT LIGHT. ANYONE KNOW HOW?
2008 Chrysler Sebring Touring Sedan FWD
-
Maintenance & Repair
I have a Chrysler 2008 Convertible Sebring Touring (2.7 V6 Engine). I recently got my car to start up again (after getting an oil change and a new battery), but I still feel unsafe to drive it. It s...
2008 Chrysler Sebring Touring Convertible FWD
-
Maintenance & Repair
CarGurus has 36 nationwide Sebring listings starting at $6,995.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.