Please help

Asked by GuruSWF1M May 19, 2019 at 08:53 AM about the Ford Bantam

Question type: General

Hi i did my head gasket on my bantam dura tec i
started it yesterday it sounded perfect was idling
for about half an hour then just cuts of so i fount
the cut of switch to reset i pressed it now im
getting fuel thru im getting spark bur still doesn't
want to start what could it be?

1 Answer

16,475

Is it cranking and not starting ? Check the Power hold relay and the main relay. If it sflooded, Press the accelerator pedle at wide open throttle and then crank. At wise open throttle and cranking speed, the PCM sees the PCM is at this state and it wont inject. This is known as a de-choke system. Check the plug gaps are at 1.00 mm.

Your Answer:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,170
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,120
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.