how to remove the driver's front seat on buick lucerene?
Asked by migration_milcurt Aug 08, 2015 at 02:14 PM about the 2010 Buick Lucerne
Question type: Maintenance & Repair
seat is jamed and wont slide but about 4 inches on one side when trying to adjust
10 Answers
Most seats have mounting bolts on the floor. If you want to remove entire seat assembly I would lubricate the bolts on the bottom of the vehicle as well.
By bottom of the vehicle you mean
By bottom of the vehicle you mean inside or under the vehicle?
Well, you unbolt the seat from the inside of the vehicle but the bolt threads go through the body to the outside underneath the vehicle. I recommend people to spray some lubricating spray on the bolt threads because they can be rusted and seized.
migration_milcurt answered 8 years ago
I see that in the glide track some round headed pins or bolts but no way to attach and tools to unscrew them. Is this the mounting bolts you are referring to?
migration_milcurt answered 8 years ago
do you have a diagram showing the location of the bolts? Thank you for your help.
The glide track assembly is considered one piece. Look on the floor where the carpet is and there should be four mounting bolts there two in the front and two in the rear.
No. In this case only two in the back. To get the seat out, tilt the seat forward after the two bolts in the back are out, thne one at a time pull the front mounting brackets up and to the rear of the car by grabing the seat and pulling. The track will pop right out.
Does anyone know how to move the seat backwards after the electronic part fails. I need to find out if there is a way to scoot it back without removing the whole seat it is stuck in the forward position
There are just 2 rear bolts to remove. Then pull out headrest using small. Tool in hole on left side of headrest pin. Then tilt seat forward and front of seat will pop out of floor. No bolts to loosen on front of seat.
